Technics SA EX140 Owners Manual
This is the 20 pages manual for Technics SA EX140 Owners Manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from Technics SA EX140 Owners Manual (Ocr-read)
Page 1
'Ibchnics"
AV Conh'ol Stereo Receiver
Operating Instructions
Model No. SA-EX 140
Emma connacunq. opal-11mg or udlusllng mls product. please read
these :nslvucflons completely
Phase keep thus mlnual lot lulmo Menace;
__P_: -C RQT5221 -P
Page 2
Dear Customer
Thank you for purchasing this product.
For optimum performance and safety, please read these
instructions carefully.
Table of contents
Precautions
Accessories
Concerning the remote contro
Front panel controls.....
Equipment connection
Antenna connections
Before use -
Navies)!»
Basic operations .......
To adjust the tone quality.
To adjust the sound balance
To mute the sound level ttttttttttttt
Listening to radio broadcasts
Sequential tuning
Direct tuning .
Preset tuning
Making a recording
Recording on a tape deck.
Recording on a VCR.....
To listen through headphones
Using the remote control
To operate the receiver
To operate CD changers (or CD players)
To operate a cassette deck.
To watch TV broadcasts...
To watch video tapes ........
To operate laser disc player
oummw-oooioioioto
Troubleshooting guide
Listening caution
Maintenance
Product serVIce
Technical specifica
..19
.Back Cover
User memo:
DATE OF PURCHASE
DEALER NAME
DEALER ADDRESS
TELEPHONE NUMBER -
The model number and serial number of this product can be
found on either the back or the bottom of the unit.
Please note them in the space provided below and keep for
future reference
MODEL NUMBER SA-EX140
SERIAL NUMBER
2
ROT522t
- THE FOLLOWING APPLIES ONLY IN THE u.s.A.
CAUTION:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. '
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the fol-
lowing measures:
0 Reorient or relocate the receiving antenna.
0 Increase the separation between the equipment and receiver.
0 Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
I Consult the dealer or an experienced radio/TV technician for
help.
Any unauthorized changes or modifications to this equipment
would void the user's authority to operate this device.
This device complies with Pan 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR PRODUCT DAMAGE, DO NOT
EXPOSE THIS APPLIANCE TO RAIN, SPLASH-
ING, DRIPPING OR MOISTURE.
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
a _ CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within
_an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous
voltage" within the products enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (sen/icing)
instructions in the literature accompanying the
appliance.
Page 4
Before use -
ROT5221
Transmission
window
Avoid any obstacles
About 7 meters (23 feet) in from
ol the signal sensor. (The actual
range will depend on the angle
at which the remote control is
used)
Accessories E!
Please check and identify the supplied
accessories
@ El AC power supply cord (RJAOOGS-A) .............................. 1 pc.
® 1:] AM loop antenna set (RSAOOlO) _
I AM loop antenna ...................................................... 1 pc.
0 AM loop antenna holder.
0 Screw .........................
© lj FM indoor antenna (RSAOOOG) ....................................... 1 pc.
@ [:1 Batteries, ...... 2 pcs.
El Remote control transmitter (EUR644346) ....................... 1 pc.
Use numbers indicated in parentheses when asking lor replacement
pans.
(Only for U.S.A.)
To order accessories contact 1-800-332-5368 or web site
(http://www.panasonic.com).
The included AC power supply cord is for use with this unit only. Do
not use it with other equipment,
Concerning the remote control'
Battery installation E
| Use of batteries I
0 Align the poles (+ and -) properly when inserting the batteries.
0 Do not mix old and new batteries or different types of batteries.
0 Do not recharge ordinary dry cell batteries.
0 Do not heat or disassemble the batteries. 00' not allow them to
contact flame or water,
0 Remove the batteries if the unit is not to be used for a long time.
0 Do not keep together with metallic objects such as necklaces.
0 Do not use rechargeable type batteries.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
It electrolyte leaks from the batteries. consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any
part oi your body.
Correct method of e
I Operation notes -I
0 Do not place obstacles between the remote control signal sensor
and remote control unit,
0 Do not expose the remote control signal sensor to direct sunlight
or to the bright light oi fluorescent light,
0 Take care to keep the remote control signal sensor and end of
the remote control unit tree from dust.
I If this unit is installed in a rack with glass doors, the glass doors'
thickness or color might make it necessary to use the remote
control a shorter distance from the unit.
To prevent damage
0 Never place heavy items'on top of the unit.
I Do not disassemble or reconstruct the unit.
I Do not spill water or other liquids into the unit,