Tandberg TPR 3080 A Owners Manual

Page 2

READ THlS FIRST!

For your safety!

To prevent electrical shock or fire, do not expose
electronic products to rain or moisture, and do
not remove covers (or back). If anything fails,
leave the repair to a qualified technician.

Pull out the power plug during thunder storms
and when you are away for a long time (e.g.
holidays, etc.).

Warning!

Faults on the units caused by the circumstances
described in the warnings below, do not ne-
cessarily apply for warranty service.

Main power

In some areas the main power wall outlet carries
high frequency data and intercom communi-
cations. To prevent this high frequency to reach
the receiver/power amplifier, an HF filter should
be connected in the power line. Ask your local
Tandberg dealer if this high frequency is in

your area. Should this high frequency reach

the receiver/power amplifier, and interfere

with the electronics, damage may occur in the
outputstage or the speakers.

Connecting

When connecting the units in a Hl-Fl system
together, it is very easy to touch the hot wire on
the phone lead and generate a hum signal. This
signal can be amplified and cause damage to

the receiver/power amplifier or the speakers.

To avoid this problem, switch off all the units

in the system before connecting.

Speaker connection

Use speaker systems with two speaker Wires

(+ and +) to each speaker. Some speaker systems
have common ground between the speakers,

and this may cause oscillation. If this type of
speaker system with common ground is used,
damage may occur in the receiver/power amplifier
or speakers.