Sony ta e 9000 es owners manual

Page 2

-
WARNING

To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.

Do not install the

appliance in a confined *

space, such as a bookcase
or built-in cabinet.

For the customers in United States

to... menus m m. .v nicm h
more... rattan.

uttllmmmruognt were...

This symbol is Intended to alert the user to
the presence of uninsulated dangerous
voltage" within the products enclosure
that may he of sufficient magnitude to
constitute a risk of electric shock to
persons.

&

This symbol is intended to alert the user to
the presence of importantfoperating and
maintenance (servicing) instructions in the
literature accompanying the appliance

INFORMATION

This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules.

These limits are designed to provide
reasonable protection against harmful
interference in a residential installation
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. if this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following mcasu res:

268

Kcu- t -: nut-nu mt» mou-

anlcuna

- Increase the separation bet eon the
equipment and control amplifier.

~ Lonnect the equipment into an outlet on
a circuit different from that to which the
control ampliticr Is connected,

7 Consult the dealer or an e\perienced
radio/TV technician for help.

CAUTION

You are cautioned that an_v changes or
modification not t~\presslv approved In
this manual could void your authority to
operate this equipment.

Note to CATV system installer:

This reminder is provided to call CATV
system installer s attention to Article 820-
40 of the NEC that provides guidelines for
proper grounding and, in particular,

s cifies that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable
entry as practical.

Owner's Record

The model and serial numbers are located
on the rear of the unit. Record the serial
number in the space provided below.
Refer to them whenever you call upon
your Sony dealer regarding this product.

Model No. TA-E9000ES
Serial No.

For the customers in Canada

CAUTION

TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
[NSERTED TO PREVENT BLADE

EXPOSURE.
@7

Precautions

0n safety

Should am solid obiect or liquid tall into
the cabinct. unplug the control amplifier
and have it checked b_v qualified personnel
before operating it any further.

On power sources

0 Before operating the control amplifier,

check that the operating voltage is

identical with your local power supply.

The operating \ oltage is indicated on the

nameplate at the rear of the control

a mpliticr.

The unit is not disconnected from the AC

power source (mains) as long as it is

connected to the wall outlet, even if the

unit itself has been turned off.

If you are not going to use the control

amplifier for a long time, be sure to

disconnect the control amplifier from the

wall outlet. To disconnect the AC power

cord, grasp the plug itself; never pull the

cord.

- AC power cord must be changed only at
the qualified service Shop

On placement

0 Place the control amplifier in a location
with adequate ventilation to prevent
heat buildup and prolong the life of the
control amplifier.

0 Do not place the control amplifier near
heat sources, or in a place subject to
direct sunlight, excessive dust or
mechanical shock.

0 Do not place anything on top of the
cabinet that might block the ventilation
holes and cause malfunctions.

On operation

Before connecting other components, be
sure to turn off and unplug the control
amplifier.

0n cleaning

Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a mild
detergent solution, Do not use any type of
abrasive pad, scouring powder or solvent
such as alcohol or benzine.

If you have any question or problem
concerning your control amplifier,
please consult your nearest Sony
dealer.