Sony STR de 405 Owners Manual
This is the 23 pages manual for Sony STR de 405 Owners Manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from Sony STR de 405 Owners Manual (Ocr-read)
Page 1
S O-NY 3-810-996-2112)
3
FM Stereo
~ FM-AM Receiver
Operating Instructions
STR-DE505
STR~DE405
STR-D4502
STR-D35OZ
Page 2
WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
'1 his symbol is intended to alert the user
to the presence of uninsulated
"dangerous voltage within the
prntiuct's
enclosure that tnay be insufficient
magnitude l0 constitute a risk nt electric
shock to persons
&
Ih symbol is intended to alert the user
to the presence of important operating
and maintenance (servicingl
instructions in the literature
accompanying the appliance
IMPORTANT
'1 his equipment has been tested and
found to comply With the llml|S kir a .
Class 8 digital device, pursuant t0 Part
l5 oi llll FCC Rules
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation
This equipment generates, uses, and can
radiate radio frequency energy and, it
not installed and used in accordance
With the instructions, may cause
harmful interference to radio
communications However, there is no
guarantee that interference Will not
occur in a particular installation. If this
equipment does cause harmiul
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures,
~ Reorient or relocate the receiving
antenna.
- increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced
radio/iv lei-human tor heir
CAUTION
You are cautioned that any change or
modifications not expressly approved in
this manual could void your authority
to operate this eqittpmenl,
Note to CATV system installer
This reminder is provided lo call the
CATV system installers attention to
Article 82040 (if the NEC that provides
guidelines tor proper grounding and. in
particular, speCifies that the cable
ground shall be connected to the
grounding system of the building, as
close to the point at cable entry as
practical
Owners record
The model and serial numbers are
located on the rear of the unit, Record
the serial number in the space proVidett
belniv Refer to them whenever you call
upon your Sony dealer regarding this
product
Model No. STR-DESUS lSTR-DE405/
STR~D4BOZ/ STR-DJSDZ
Serial No
-
Precautions
0n saiety
. should any solid obiect or liquid till
into the cabinet, unplug the receiver
and have it checked by qiialitied
personnel before operaling it ani-
further
0n power sources
Before operating the receiver, check
that the operating voltage is identical
WIllt your local power supply, The
operating voltage is indicated on the
nameplate at the rear of the receiver
The receiver is not disconnected from
the AC power source (MAINS) as
long as it is connected to the wall
outlet, even if the receiver itself has
been turned oil
it you are not gouty; to use the
receiver tor a long time. be sure to
disconnect the receiver from the ivall
nutlct 'lo disconnect the AC power
cord, grasp the plug itself, never pull
the cord
Ont» blade at the plug is Wldtr than
the other for the purpose of safety
and will fit into the wall outlet only
one way. if you are unable to insert
the plug fully into the outlet, contact
your dealer
Should the AC power cord need to be
changed, have it done at a qualitied
sen/ice Shop only
0
0n placement
Place the receiver in a location with
adequate ventilation to prevent heat
buildup and prolong the life or the
receiver
Donut place the receiver near heat
sources, or in a place suhiect to direct
sunlight, excessive dust or
mechanical shock,
Do not place anything on mp m the
cabinet that might block the
veniilatlun holes and cause
malfunctions
On operation
- Before connecting other components,
be sure to turn off and unplug the
receiver
0n cleaning
- Clean the cabinet, panel and controls
With a salt cloth slightly moistened
With a mild detergent solution. Do
not use any type of abrasive pad,
scouring powder or solvent such as
alcohol or benzine.