Sony str d 965 owners manual

Page 1

SoNx

----------- (2)

FM Stereo
FM-AM Receiver

Operating Instructions

STR-0965
STR-0865

5 by Sony Corporanon

Page 2

a,

-
WARNING

To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.

CAUTION
-
DONOTOPEN .

AUTION TO HEDUCE THE HISK 0F ELECTRIC
SHOCK.

DO NOT REMOVE COVERIOR BACK). ,7

N0 USERSERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE.
PERSONNEL

A ,

This symbol is intended to alert the user
to the presence of uninsulated
"dangerous voltage" within the products
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.

This symbol is intended to alert the user
to the presence of important operating
and maintenance (servicing) instructions
in the literature accompanying the
appliance.

IMPORTANT

This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules.

These limits are designed to provide
reasonable protection against harmful
interference in a midential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:

- Reorient or relocate the receiving
antenna.

- Increase the separation between the
equipment and receiver.

. Canned the equipment into an outlet
on a circuit different from that to which
the receiver is connected

- Consult the dealer or an experienced
radio/ TV technician for help.

CAUTION

...You are cautioned that any change or

modifications not expressly approved in
this manual could void your authority to
operate this equipment.

Note to CATV system installer

This reminder is provided to call the
CATV system installer s attention to
Article 82040 of the NEC that provides
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding
system of the building, as close to the
point of cable entry as practical.

Owner's record

The model and serial numbers are located
on the rear of the unit. Record the serial
number in the space provided below.
Refer to them whenever you call upon
your Sony dealer regarding this product.

Model No. STR-D965/STRD865
Serial No.

For the customers in Canada

CAUTION .
TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
lNSERTED TO PREVENT BLADE
EXPOSURE

_
Precautions

0n safety

- Should any solid object or liquid fall
into the cabinet, unplug the receiver
and have it checked by qualified
personnel before operating it any
further.

On power sources

- Before operating the receiver, check
that the operating voltage is identical
with your local power supply. The
operating voltage is indicated on the
nameplate at the rear of the receiver.

0 The receiver is not disconnected from
the AC power source as long as it is

connected to the wall outlet, even if the
receiver itself has been turned off,

I If you are not going to use the receiver
for a long time, be sure to disconnect
the receiver from the wall outlet. To
disconnect the AC power cord, grasp
the plug itself; never pull the cord.

0 One blade of the plug is wider than the

other for the purpose of safety and will

fit into the wall outlet only one way. If
you are unable to insert the plug fully
into the outlet, contact your dealer.

Should the AC power cord need to be

changed, have it done at a qualified

service shop only.

On placement

0 Place the receiver in a location with
adequate ventilation to prevent heat
build-up and prolong the life of the
receiver.

0 Do not place the receiver near heat

sources, or in a place subject to direct

sunlight, excessive dust or mechanical

shock.

Do not place anything on top of the

cabinet that might block the ventilation

holes and cause malfunctions.

0n operation

' Before connecting other components,
be sure to turn off and unplug the
receiver.

0n cleaning

0 Clean the cabinet, panel and controls
with a soft cloth slightly moistened
with a mild detergent solution. Do not
use any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.