Sony str d 360 z owners manual

Page 2

WARNING

To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.

.a on. lmr uni-ea.

mandamus-mm

This symbol is intended to alert the user
to the presence oi uniustilnted
dangerous voltage" Within the
product's enclosure that may be of
sufiictent magnitude to constitute a risk
or electric shock to persons.

&

This symbol is intended to alert the user
to the presence of important operating
and maintenance (servicing)
instructions in the literature
accompanying the appliance,

IM PORTANT

This equipment has been tested and
found to comply with the limits tor a
Class B digital device, pursuant to Part
15 of the FCC Rules

These limits are designed to provide
reasonable protection against harmtul
interference in a residential installation,
This equipment generates, uses, and can
radiate radio trequency energy and, it
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment oil and on, the
user is encouraged to try to correct the
interference by one or more of the
tollowing measures-

- Rsuncut or relocate the receiving
antenna

~ Increase tlw separation bthttu tllt'
equlpnwnt and rettn'tr

, Connect the equipment into an outlet
on it cimtit tiittereitt truth that in
which the receiver is connected
Consult the dealer or an experienced
radio/TV technician tar help

CAUTIO N
You are cautioned that any change or

modifications not estpressly approved in-

this manual could void your authority
to upurate this equipment.

Note to CATV system installer

This reminder is provided to call the
CATV system installers attention to
Article 820740 oi the NEC that provides
guidelines tor proper grounding and, in
particular, specifies that the cable
ground shall be connected to the
grounding system or the building, as
close to the point oi cable entry as
practical

Owners record

The model and serial numbers are
located on the rear of the unit Record
the serial number in the space provided
below. Refer to them whenever you call
upon your Sony dealer regarding this
product.

Model No. STRrDES l 5 / STR-DEAHS/

STRVDE315 /STRVD4602/
STR-DBSUZ

Serial No

_
Precautions

0n safety
Should any solid obicd or liquid tall

into the cabinet, unplug the receiver
and hare it checked hy qnnlitnd
personnel tietnri- operating it any
iurthor,

on power sources

- Before operating the receiver, checlt
that the operating voltage is identical
with your local power supply. The
operating voltage is indicated on the
nameplate at the rear oi the receiver
The receiver is not disconnected from
the AC power source (MAINS) as
long as it is connected to the wall
outlet, even if the receiver itself has
been turned off .

- It you are not going to use the
receiver tor a long time, be sure to
disconnect the receiver from the wall
outlet. To disconnect the AC power
cord, grasp the plug itself; never pull
the cord.

One blade of the plug is wider than
the other tor the purpose of satety
and will tit into the wall outlet only
one way. It you are unable to insert
the plug fully into the outlet, contact
your dealer. (us model only)

Should the AC power cord need to be
changed, have it done at a qualitied
seerce shop only.

0

O n p Ia cement

. Place the receiver in a location with
adequate ventilation to prevent heat
build-up and prolong the lite oi the
receiver.

Do not place the receiver near heat
sources, or in a place subject to direct
sunlight, excessive dust or
mechanical shock.

Do not place anything on top of the
cabinet that might block the
ventilation holes and cause
malfunctions.

0n operation

- Before connecting other components,
be sure to turn off and unplug the
receiver.

0n (lea iting

- Clean the cabinet, panel and controls
with a soft cloth slightly moistened:
with a mild detergent solution. Do
not use any type at abrasive pad,
scouring powder or solvent such as
alcohol or benzine.