Sony rm v 8 owners manual

Page 2

Commander

This Remote Commander can operate any of the
following video components, If youre using this
Commander with a Sony brand TV and a Sony
brand VHS VCR, you won't need to preset the
Commander before you start using it However,
you will need to set up the Commander if it cannot
operate even a Sony brand component and you
have a cable box. Each component is assigned a
different button on the Commander:

Component Button Factory
Type Preset

TV TV' Sony TV

VCR vcn' Sony vHs VCR
Cable box CABLE ~

' You can assign your TV/ VCR combo on either of
these buttons

If You Do Not Have Sony
Components...

You'll need to follow. the instructions in this manual
to preset the Remote Commander with the correct
code numbers for each of your components.

-
Installing the
Batteries

Slide open the battery compartment and insert two
size AA batteries (not supplied),

Be sure to line up the e and 5 on the batteries with
the 9 and Q on the battery compartment.

Aim at your
component

Done

Step 1: Entering the Code
Number

1 Press and release the 5 (Set) button.

2 Press the button of the component that you
want to set up. VCR CABLE TV

CH:U:)

3 Turn to "Component Code Numbers" and find
the two«digit code number for your component.

If more than one code number is listed, use the
number thats listed first to complete the steps
that follow.

For example, if you're setting up a Philips VCR,
you would use code number 10.

Brand Component Code No.

Philips VCR 10, 08, 09

If your component is riot listed, see "Searching
for the Correct Code.

4 Enter the components code number

For example, if youre entering the code for a
Philips VCR, you would press and release 1,

then press and release 0.

Your Code Number

5 Press and release the ENT (Enter) button to store
the code number in the Commanders memoryi

@

6 Go to "Step 2: Checking if the Code Number
Works" to finish setting up.