Sony rm v 7 owners manual

Page 2

0.0....

Commander

This Remote Commander can operate any of the
following video components. If youre using this

Commander with a Sony brand TV and a Sony *
brand VHS VCR, you wont need to preset the Aim at your -
Commander before you start using it. However, component
you will need to set up the Commander if it cannot '
operate even a Sony brand component and you NO
have a cable box. Each component is assigned 3 ®
different button on the Commander: YES
Component Button Factory 0°
Type Preset
TV 7 5°"YTV Step 1: Entering the Code
VCR VCR Sony VHS VCR N umber
Cable box

CABLE -

' You can assign your TV/ VCR Combo on either of
these buttons,

If You Do Not Have Sony
Components...

You'll need to follow the imtructions in this manual
to preset the Remote Commander with the correct
code numbers for each of your components.

_
Installing the
Batteries

Slide open the battery compartment and insert two
size AA batteries (not supplied).

Be sure to line up the 9 and O on the batteries with
the 9 and 9 on the battery compartment.

1 Press and release the S (Set) button.

2 Press the button of the component that you
want to set up.

VCR CABLE TV

3 Turn to "Component Code Numbers" and find
the two-digit code number for your component.

If more than one code number is listed use the
number that's listed first to complete the steps
that follow.

For example, if youre setting up a Philips VCR,
you would use code number 10.

Brand Component Code No.

Philips VCR 10, 08, 09

If your component is not listed, see Searching
for the Correct Code".
4 Enter the component's code number.

For example, it youre entering the code for a
Philips VCR, you would press and release 1,

then press and release 0

Your Code Number