Sony rm v 12 owners manual

Page 2

Cable box CBL
TV TV Set to AV
mu
m . i i .w
VCR VCR - (ontinue with
Receiver/amp, CD player, tape deck, AV procedures
or a second TV, VCR, or cable box

SLEEP

-.
V
+@- .

If You Have Sony Components...
You wont need to set up the Commander before you Enter code for

start using it. (This Commander is preset at the factory component type
to operate Sony brand components.) However, you will

need to set up the Commander if you have a cable box. -
Also, slide swnch position AV is factory preset for Sony Component Code
receivers. if you want to control different component VCR i
with AV, you must first set up the Commander as -___Re .v / 4
described following w

CD player 5

Ta e detk 6
If You Do Not Have Sony NP 8
Components" . Cable box 9
Youll need lo follow the instructions in this manual to
preset the Remote Commander with mu correct code
numbers for each of your components. ,

. Step 1: Entering the Code Number
If You Have Video Components that ityuu ow suiiiug up_ the Commander tovupcrdtc
Are Connected to an Audio System... 5.
See "Setiing Up Video Coinpnnenls That Are AV. 3

Connected to an Audio System".
1 Set the slide switch on the
Remote Commander to the

__ position of me component that
Installing the Batteries YO Wm?

Slide open the battery compartment and insert two size 2 See Component Code Numbers", and find the
AA batteries (not supplied). twomharacter code number for your component.

Be sure to line up the 0 and O on the batteries with the

9 and g on the battery compartment. If more than one code number is listed, use the

number thats listed first to complete the steps that
follow.

For example, if youre setting up a Philips VCR,
you would use code number 10 I

Brand Component Code No.
Philips VCR 10, 08, 0)

if your component is not listed, see Searching for

the Correct Code".

3 Press the POWER button SLEEP
while pressing the SLEEP "
button.

4 Enter the components code

number. (9 ®
For example, if youre entering

the code for a Philips VCR, you VOL" Code
would press and release 1, then NUMbe'
press and release 0.

Notes on Batteries
- Under normal conditions, batteries will last up to six
months. If the Remote Commander does not operate

properly, the batteries might be worn out. When 5 Press and release the ENT button ___,,..4.. e. . ,_,._,,_,s.._s....... m0...»
replacing batteries, replace both of them with new .0 store the code number in the
ones. Commanders memory. -
- Do not mix old batteries with new ones or mix
different types of batteries together. 6 Go to "Step 2: Checking if the Code Number

Works to finish setting up