Sony rdr vx 500 owners manual

Page 2

WARNING

To prevent lire or shock hazard,
do not expose the unit to rain or
moisture.

To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualitied personnel only.

The AC power cord must be
changed only at a qualified
service shop only.

CLASSi LASER PRODUCT
LASER KLAssEi

LUOKAN t LASERLAITE
KLAss i LASERAPPARAT

This appliance is clat ified as a
CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT
MARKING is located on the rear
exterior.

CAUTION

The ttse of optical instruments with this
product will increase eye hazard, As
the laser beam used in this VCRrDVD
recorder is hariiiflil to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel
only.

a-a

This symbol is intended
I0 alert the user ID the
presence of uninsulated
dangerous voltage"
within the product's

enclosure that may be of sufficient

magnitude to constitute a risk of
electric shock to persons.

This symbol is intended
to alert the user to the
presence of important
operating and
maintenance (servicing)
instmctions in the literature
accompanying the appliance.

CAUTION

TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE 0F PLUG
TO WIDE SLOT. FULLY INSERT.

CAUTION

You are cautioned that any change or
modifications not expressly approved
in this tnanual could void your
attthority to operate this equipment.

This eqUipinent has been tested and
found to comply with the limits for a
Class B digital device. pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses. and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off anti on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:

7 Reorient or relocate the receiving
antenna.

7 Increase the separation between the
equipment and receiver,

7 Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.

7 Consult the dealer or an experienced
radio/TV technician for help.

VCR l>lus+ and PlusCode are
registered trademarks of Genistar
Development Corporation. The VCR
Plus+ , stem is manufactured under
license front Gemstar Development
Corporation.