Sony rdr hx 900 owners manual

Page 2

WARNING

To prevent lire or shock hazard,
do not expose the unit to rain or
moisture.

To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualitied personnel only.

The AC power cord must be
changed only at a qualified
service shop only.

CAUTION

The ttse of optical instruments with this
product will increase eye hazard. As
the laser beam used in this DVD
recorder is harmful to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel
only.

This symbol is Intended

to alert the user to the

presence of uninsulated

dangerous voltage"

within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.

This symbol is inteitded
to alert the user to the
presence of important
operating and
maintenance (servicing)
instmctions in the literature
accompanying the appliance.

For customers in the us}:

Dwner's Record

The model attd set-ml numbers are located at
the rear of the utitt.

Record the set-tat number itt Lhc space
provided below Reter to them

whenevcr you call upon your Sony dealer
regarding this product.

Model No. RDRVHX9UO

Serial No

CAUTION

You are cautioned that any change or
modifications not expressly approved
in this manual could void your
authority to operate this equipment.

This equipment has been tested and
found to comply with the limits for a
Class B digital device. pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses. and can
radiate radio frequency energy and, if
not installed aiid used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception. which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:

, Reorient or relocate the receiving
antenna.

, Increase the separation between the
equipment and receiver,

, Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.

, Consult the dealer or an experienced
radio/TV technician for help.

VCR Plus+ and PlusCode are
registered trademarks of Genistar
Development Corporation. The VCR
Plus+ system is manufactured under
license from Gemstar Development
Corporation.

in the United States. TV GUIDE and
other related lnarks are registered
marks of Gemstarrrv Guide
ittternationai, Inc, and/or one of its
affiliates, in Canada. TV GUIDE is a
registered mark of Transcontinental
inc, and is used under license by
GetiistarrTV Guide international. Inc.
The Tv Gutde On Screen system is
manufactured under license from
GenistarrTV Guide international. inc
and/or one of its affiliates.

The TV Guide On Screen systetn is
protected by one or more of the
following issued United States patents
6,498.895, 6,418,556, 6.331.877;
6,239.79 o,l54,2o 5,940,073;
4908.71 ,4.751,57 ,4,7oo,121.

Precautions

This equipment has been tested and
found to comply with the limits set
out in the EMC Diieetive using a
connection cable shorter than 3
meters.

On safety

Should any solid object or liquid fall
into the cabinet, unplug the recorder
and have it checked by qualified
personnel before operating it any
further.

About the hard disk drive

The hard disk has a high storage
density, which enables long
recoiding durations and quick
access to the written data. However,
it can easily be damaged by shock.
vibration or dust. and should be kept
away from magnets. To avoid losing
impoitant data, observe the
followmg precautions.

Do not use the recorder in a place
sublect to extreme changes iii
temperature (temperature gradient
less than 10 °C/hour).

Do not apply a strong shock to the
iecorder.

Do not place the recoider in a
location subject to mechanical

vibrations oi in an unstable
location.

Do not place the recorder on top of
a heat source, such as a VCR or
AV amplifier (receiver).

Do not move the recordei with its
AC power cord connected.

Do not move the recorder for one
minute after you have unplugged
the AC power cord. After one
minute, move the recorder without
shock or vibration.

Do not disconnect the AC power
cord while the power is on.

Do not attempt to change the haid
disk. This may result in a
malfunction.

Should the hard disk be damaged,
you cannot recover lost data. The
hard disk is only a temporary
storage space.

0n placement
- Place the recorder in a location
with adequate ventilation to