Sony rdr gx 7 owners manual

Page 2

WARNING

To prevent fire or shock hazard, do not
expose the unit to rain or moisture.

To avoid electrical shock, do not open
the cabinet. Refer servicing to qualified
personnel only.

The AC power cord must be changed
only at a qualified service shop only.

CAUTION

The use of optical instruments with this
product will increase eye hazard. As the
laser beam used in this DVD recorder is
harmful to eyes, do not attempt to

dis ssemble the cabinet.

Refer servicing to qualified personnel
only.

This symbol is itttended to alert the
user to the presence of uninsulated
dangerous voltage" within the
prod . s enclosure tltat may be of
sufficient magnitudetoconstitutearisk
of electric shock to persons.

This symbol is intended to alert the
user to the presence of important
operating and tnaintenance (servicing)
instructions in the literature
accompanying the appliance.

CA UTIO N
TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT,

For customers in the U.S.A

Owner's Record

The model and serial numbers are located at the rear
of the unit. Record the serial number in the space
provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.

Model No, RDRVGX7
Serial No.

CA UTIO N

You are cautioned that any change or modifications
not expressly approved in this manual could void
your authority to operate this equipment,

This equipment has been tested and found to comply
with the limits for a Class B digital deVicc. pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses, and cart radiate
radio freqttency energy and. if not installed and used
to accordance With the instructions, tnay cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation, If this
cqutpntent does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the followrng measures:

, Reorient or relocate the receiving atttenna.

, Increase the separation between the equtptnent and
receiver.

7 Connect the equipment into an otttlet on a circuit
different from that to which the receiver is
connected.

7 Consult the dealer or ati experienced radio/TV
technician for help.

VCR Plus+ and PlusCode are registered
trademarks of Gemstar Development
Corporation. The VCR Plus+ system is
manufactured under license from
Gemstar Development Corporation.

2 WARNING

Precautions

This equipment has been tested and
found to comply with the limits set out in
the EMC Directive using a connection
cable shorter than 3 meters

On safety

Should any solid object or liquid fall into
the cabinet, unplug the recorder and have
it checked by qualified personnel before
operating it any further.

On power sources

' The recorder is not disconnected from
the AC power source as long as it is
connected to the wall outlet, even if the
recorder itself has been turned off.

- If you are not going to use the recorder
for a long time, be sure to disconnect
the recorder from the wall outlet. To
disconnect the AC power cord, grasp
the plug itself; never pull the cord.

On placement

- Place the recorder in a location with
adequate ventilation to prevent heat
build-up in the recorder.

' Do not place the recorder on a soft

surface such as a rug that might block

the ventilation holes.

Do not place the recorder in a confined

space such as a bookshelf or similar

unit.

Do not place the recorder in a location

near heat sources, or in a place subject

to direct sunlight, excessive dust, or

mechanical shock.

Do not place the recorder in an inclined

position. It is designed to be operated

in a horizontal position only.

Keep the recorder and discs away from

equipment with strong magnets, such

as microwave ovens, or large

loudspeakers.

Do not place heavy objects on the

recorder.

To prevent fire or shock ha' ard, do not

place objects filled with liquids, such

as vases, on the apparatus.

On operation

' If the recorder is brought directly from
a cold to a warm location, or is placed
in a very damp room, moisture may
condense on the lenses i ide the
recorder. Should this occur, the
recorder may not operate properly. In
this case, remove the disc and leave the
recorder turtted on for about half an
hour until the moisture evaporates.

- When you move the recorder, take out
any discs. If you don't, the disc may be
damaged.