Sony mhc rxd 2 owners manual

Page 1

S ON'Y. 3%6-221-11)

Mini Hi-Fi
Component
System

Operating Instructions

Owner's Record

The modelnnd serialnumbersan leaked on the IEIIPIML Record the serial
number in the space provided below we: to them whencvzr you call upon yaur
Sony dealer legarding this product

Model No - Serial No

@1315

MHC-RXD2

©1998 by Sony Corporation

Page 2

To prevent fire or shock hazard. do not
expose the unit to rain or moisture.

To avoid eleetrical shock do not open the cabinet.
Refer servicing to qualified personnel only.

Do not install the appliance in a wired space,
such as a bookcase or built-in cabinet.

This appliance is classified
m,mm as: cmssrmsck

mm mum-e product The cursor
m w" "" msm PRODUCT
MARKING is located on

the rear exterior.

This symbol is intended to alert the
user to the preseme of unimulated
"dangerous voltage" within the
products enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.

This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.

CAUTION

The use of Optical instruments with this product will
increase eye hanrd.

INFORMATION
'Ihisequiprnmthasbeentestedandfouidto
comply with the limits for u Class 3 digital device,
pursuant to Part 15 of the KC Rules. Time limits
are designed to provide msomble protection
against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate ndio frequency Energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio
communimtions. However, there is no guarantee
matinterfererwewillnmoocurinaparfimlar
installation it tho equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment «fund
on, the userisenoouraged too-ytooomctthe
interference by one or more of the following
measures:

- Reorient or relocate the reoeiving antenna

-- Increase the separation between the equipmait
and receiver.

- Connect the equipment into an outlet on a cimiit
different from that to which the receiver is
connected

- Consult the dealer or an experienced radio/ TV
technician {or help

CAUTION

You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment

Note on CATV system Installer:

Ths reminder is provided to all CATV system
installers attention to Article 820-40 of the NEC that
provides guidelinai for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building.
as close to the point of cable entry as practical.