Sony mhc 1600 owners manual

Page 2

I
\
1

, Owners Record

The model and serial numbers are located at the rear. Record
these numbers in the spaces provided on the right. Refer to them
whenever you call upon your Sony dealer regarding this product.

To prevent fire or shock hazard, do not
expose the unit to rain or moisture.

RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE,

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol is intended to alert the user to
the presence of uninsulated dangerous
voltage within the products enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to
persons.

This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.

For the customers in Canada

CAUTION:

TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS
POLARIZED AC PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.

This apparatus complies with the Class B limits for radio
noise emissions set out in Radio Interference Regulations.

2

Model No. HOD-H1600 Serial No.
Model No. TC-HIGOO Serial No.
Model No. SS~H1600 Serial No.

For the customers In the U.S.A.
INFORMATION

This equipment generates and uses radio frequency energy
and if not installed and used properly, that is, in strict
accordance with the manufacturers instructions, may cause
interference to radio and television reception It has been
type tested and found to comply with the limits for a Class B
computing device in accordance with the specifications in
Subpart J of Part 15 of FCC Rules, which are designed to
provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause interference to radio or television
reception. which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:

Reorient the receiving antenna

Relocate the equipment with respect to the receiver

Move the equipment away from the receiver

Plug the equipment into a different outlet so that

equipment and receiver are on different branch circuits.
If necessaw, the user should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet
prepared by the Federal Communications Commission
helpful:
How to Identify and Resolve Radio-TV Interference
Problemsi This booklet is available from the U5.
Governmeanrinting Office, Washington, DC 20402. Stock
No 004-000-00345-4. ,

Note to CATV system installer:

This reminder is provided to call the CATV system
installers attention to Article 820-22 of the NEC that
provides guidelines for proper grounding and, in
particular. specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.