Sony mds je 510 service manual

Page 2

To prevent fire or shock
hazard, do not expose the unlt
to rain or moisture.

To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified
personnel only.

The laser component in this product is
capable of emitting radiation exceeding
the limit for Class 1.

Amara-1m

W Ianmfl-inxo-Etsm WK

be m mm oovrn a. stat
town-slut: "mm
armsumna m Gal r customs rilwwa,

This symbol is intended to
alert the user to the presence of
uninsulated "dangerous
voltage within the products
enclosure that may be of
sufficient magnitude to
constitute a risk of electric
shock to persons

This symbol is intended to
& alert the user to the presence of

important operating and

maintenance (servicing)

instructions in the literature
accompanying the appliance,

INFORMATION

This equipment has been tested and
found to comply with the limits for a
Class B digital devtce, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses. and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions. may cause
harmful interference to radio
communications.

However, there ts no guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or
more of the following measures:

- Reorient or relocate the receiving
antenna

7 Increase the separation between the
equipment and receiver.

~ Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.

- Consult the dealer or an experienced
radio/'I'V techmctan for help.

CAUTION

You are cautioned that any changes or
modification not expressly approved in
this manual could void your authority
to operate this equipment.

Owner's Record

The model and serial numbers are
located on the rear of the unit.
Record the serial number in the space
provided below. Refer to them
whenever you call upon your Sony
dealer regarding this product.

Model No.

Serial N o.

IN NO EVENT SHALL SELLER BE
LIABLE FOR ANY DIRECT,
INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE! OR LOSSES OR
EXPENSES RESULTING FROM ANY
DEFECTIVE PRODUCT OR THE
USE OF ANY PRODUCT

Precautions

On safety

' The use of optical instruments with
this product will increase eye hazard.

' Should any solid object or liquid fall
into the cabinet, unplug the dark and
have it checked by qualified
personnel before operating it any
further,

On power sources

- Before operating the deck, check that
the nperating voltage of the deck is
identical with your local power
supply. The operating voltage is
indicated on the nameplate at the rear
of the deck.

' If you are not going to use the deck
for a long time, be sure to disconnect
the deck from the wall outlet. To
disconnect the AC power cord, grasp
the plug itself; never pull the cord.

On operation

If the deck is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lenses inside the deck.
Should this occur. the deck may not
operate properly. in this case, remove
the MD and leave the deck turned on for
about an hour until the moisture
evaporates,

0n the MiniDisc cartridge

- Do not open the shutter to expose the
MD

Do not place the cartridge where it
will be subject to extremes of sunlight,
temperature, moisture or dust.

On cleaning

Clean the cabinet, panel and controls
with a soft cloth slightly moistened with
a mild detergent solution. Do not use
any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.

If you have any questions or problems
concerning your deck, please consult
your nearest Sony dealer.