Sony mds jb 920 owners manual

Page 2

To prevent fire or shock
hazard, do not expose the unit
to rain or moisture.

To avoidelectrical shock, do
not open the cabinet. Refer
servicing to qualified
personnel only.

The tpttnent in this product
capahl e 3 radiation

[ exceeding the limit for Class 1.

CLASS 1 LASER PRODUCT
LUOKAN I LASERLAlTE

Kmss l msERAPPARAT

This appliance is classified as 2t CLASS 1
LASER product The CLASS 1 LASER
PRODUCT MARKING is located on the
rear exterior

The following caution label is located
inside of the unit.

cAUrIoN at as. am. at. at. as
5.. 5 New" "mam;
rp- Mid l V
Wit-'W
acmmmmwawa
W ma
Maaawcwnm
mammamat Ma
amoumaamt a.
mint-cit WWW...

@
For the customers in the
United States

AEEEA

A

This symbol is intended to alert the user
to the presence at uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a risk
of electric shock to persons.

A

This wittbul |,\ Illttlttlld to tIIKVI'I the user
to the pttsuittt \I important routing
and maintenance (sort icing)
instructions in the literature

accompanying the appliance.

CAUTION
The use tti optical instruments with this
product \tlll rncronsc ere hazard

Owner's Record

The model and serial numbers itrt'
located on the rear of the unit.
Record these numbers in the spaces
provnied below. Refer to them
whenever you call upon your Sony
dealer regarding this product.

Model No, MDSVIBQZO
Serial No.

INFORMATION
This equipment has been tested and
found to comply with the limits for a
Class a digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications However, there is no
guarantee that interference will not
occur in a particular installation. II this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
a Reortent or relocate the receiving
antenna.
7 Increase the separation between the
equipment and receiver
7 Connect the equipment into an outlet
on a circuit drfterent from that to
which the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help,

I

CAUTION '
You are cautioned that any changes or
modifications not expressly approved in

» this manual could void your authority

to operate this equipment.

For the customers in Canada

CAUTION

10 IRF NI ELI.CI'RIC SHOCK, DO
NOT THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,

R ITACLF OR OTHER OUTLET
L'NLF S THF BLADES CAN BE FULLY
1N5 (T til) TO PREVENT BLADE
EXPOSURE.

IN NO EVENT SHALL SELLER BE
LIABLE FOR ANY DIRECT,
INCIDENTAL. OR
CONSEQUENTIAL DAMAGES OF

ANY NATURE, OR LOSSES OR
EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR
THE USE OF ANY PRODUCT.

-
Precautions

0n safety

Should any solid object or liquid tall
into the cabinet, unplug the deck and
have it checked by qualified personnel
before operating it any further.

0n puwer sources

- Before operating the deck, rheck that
the operating voltage of the deck is
identical with your local power
supply, The operating voltage is
indicated on the nameplate at the rear
of the deck.

The unit is not disconnected from the
AC power source (mains) as long as it
is connected to the wall outlet, even if
Ihe unit itself has been turned off,

If you are not going to use the deck
tor a long time, be sure to disconnect
the deck from the wall outlet. To
disconnect the AC power cord, grasp
the plug itself; never pull the cord.
AC power cord must be changed only
at the qualified service shop.

.