Sony mdp 212 service manual

Page 2

SAFETY CHECK-OUT

After correcting the original service problem, perform the following
safety checks before releasing the set to the customer:

1. Check the area of your repair for unsoldered or
poorly-soldered connections. Check the entire
board surface for solder splashes and bridges.

2. Check the interboard wiring to ensure that no
wires are pinched or contact high-wattage
resistors.

3. Look for unauthorized replacement parts, par»
ticularly transistors, that were installed during a
previous repair. Point them out to the customer
and recommend their replacement.

SAFETY-RELATED COMPONENT WARNINGII

COMPONENTS IDENTIFIED BY SHADING AND MARK

ON THE SCHEMATIC DIAGRAMS, EXPLODED
VIEWS AND IN THE PARTS LIST ARE CRITICAL TO
SAFE OPERATION. REPLACE THESE COMPONENTS
WITH SONY PARTS WHOSE PART NUMBERS APPEAR
AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY. CIRCUIT ADJUSTMENTS
THAT ARE CRITICAL TO SAFE OPERATION ARE
IDENTIFIED IN THIS MANUAL. FOLLOW THESE PRO-
CEDURES WHENEVER CRITICAL COMPONENTS ARE
REPLACED 0R IMPROPER OPERATION ISSUSPECTED.

4.

Look for parts which, though functioning, show
obvious signs of deterioration. Point them out
to the customer and recommend their replace-
ment.

Check the B+ voltage to see it is at the values
specified.

Remote commander RMT-loz is supplied as a
unit for service. Don't supply individual parts
except the battery case lid.