Sony lbt xb 3 k owners manual

Page 2

To prevent fire or shock haxard, do not
expose the unit to rain or moisture.
in mud electrical short, .1.» not upcn the cabinet
Reter Servicing it. qualified personnel .me

'l
r

. Do not Install the appliance In .t confined span}, i
such as a bixxkcase er built-in cabinet.

Laser component in this product is capable 0t
emitting radiation exceeding the limit for Class 1.

This appliance is classified as
a CLASS 1 LASER product.
The CLASS I LASER
PRODUCT MARKING is
located on the rear exterior

cuss v risen mi
inc-wt Assure

ms I LASERWIAI

This caution label is located inside the unit,

flame... r54": m;
mi... m... .0. mm

mm was mm m an?
- WE mm in mm

NOTICE FOR THE CUSTOMERS IN THE
U.S.A.

A%A§

mm. mimic. masses-renew
no mun-o»: m. in won
w «99me was Ill-l

ins. «mm m mien (mu unmet

This symbol is intended to alert the
user to the presence of uninsulated
"dangerous voltage" within the
products enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons,

This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature

. accompanying the appliance.

CAUTION

The use of optical instruments with this product will
increase eye hazard.

INFORM ATION

This equipment has been tested and tuund It»

rompiv with the limits for a Class B di tal device.

pt uant to Part l5 of the FCC Rules. Ihcse limits
are tie mind to provide reasonable prtitedion

agai harmful inlerieri-nce in a residential

IIISIitIIithUn I'his tqlllpnttni generates, uses. and can

radiuli radio lnquency energy .mtt, if not installed

and used In iii-rririitince with the instructions, may
cause harmful interference to radio
communications, However, there is no guarantee
that intertertnce will not occur in a partiuilar
installation. II this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and

«in, the user is encouraged to try to correct the

interference by one or more of the iollowmg

measures:

.. Rcorieut or relocate the receiving antenna.

- Increase Ihe separation between the equipment
and receiver.

-- Connect the equipment into an outlet on a circuit
dittemnt from that to which the receiver is
connected

- Consult the dealer nr an experienced radio/TV
technician for help.

CAUTION

You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.

Note on CATV system installer:

This reminder is provided to call CATV system
installers attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.

NOTICE FOR THE CUSTOMERS IN
CANADA

CAUTION:

TO PREVENT ELECTRIC SHOCK, DO NOT USE
THIS POLARIZED AC PLUG WITH AN
EXTENSION CORD,

RECEPTAC LE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.

This stereo system is equipped with the Dolby B-
type noise reduction system

Dolby noise reduction manufactured under license
from Dolby Laboratories Liceruing Corporation.
DOLBY and the double-D symbol [X] are
trademarks of the Dolby Laboratories Licensing
Corporation.