Sony htddwg 700 owners manual

Page 2

Owners Record

The model and serial numbers are located on the rear
of the unit. Record the serial number in the space
provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.

Model No.
Serial No.

To reduce the risk of fire or electric
shock, do not expose this apparatus to
rain or moisture.

To prevent fire, do not cover the ventilation of the
apparatus with newspapers, table-cloths, curtains,
etc. And don't place lighted candles on the
apparatus.

To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.

Do not install the appliance in a confined space, such
as a bookcase or built-in cabinet.

Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.

Batteries or batteries installed apparatus shall not be
exposed to excessive heat such as sunshine, fire or
the like.

For customers in the United
States

This symbol is intended to alert the
user to the presence of uninsulated
dangerous voltage within the
products enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.

2l/S

This symbol is intended to alert the
user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.

WARNING

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following mwsures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and
receiver.

- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.

- Consult the dealer or an experienced radio/T V
technician for help.

CAUTION

You are cautioned that any changes or modification
not expressly approved in this manual could void
your authority to operate this equipment.

Note to CATV system installer:
This reminder is provided to call CATV system
installers attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.