Sony htddw 830 owners manual

Page 2

WARNING

To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.

m Nor nmuv: mm (on Mm

This symbol is intended to alert the user to
the presence of uninsulated dangerous
voltage within the product's enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to
persons.

A

This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.

IN F0 RM ATIO N

This equipment has been tested and found

to comply with the limits for a Class B

digital device, pursuant to Part 15 of the

FCC Rules.

These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses, and can

radiate radio frequency energy and, if not

installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:

7 Reorient or relocate the receiving
antenna.

7 Increase the separation between the
equipment and receiver.

7 Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.

7 Consult the dealer or an experienced
radio/ TV technician for help.

2

CAUTION

You are cautioned that any changes or
modification not expressly approved in
this manual could void your authority to
operate this equipment.

Note to CATV system installer:

This reminder is provided to call CATV
system installers attention to Article 8207
40 of the NEC that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable
entry as practical.

For customers in Canada

CAUTION

TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE
EXPOSURE.

For customers in the United States and
Canada

ENERGY STAR® is a U.S.
registered mark.
As an ENERGY STAR® partner,

M Sony Corporation has

determined that this product
meets the ENERGY STARE
guidelines for energy
efficiency.

For customers in other countries

To avoid electrical shock,
do not open the cabinet.
Refer servi ng to qua
personnel only.

Do not install the
appliance in a confined
space, such as a bookcase
or built-in cabinet.

Dont throw a battery,
dispose it as the injurious
wastes.

Precautions

0n safety

- Should any solid object or liquid fall into the
cabinet, unplug the receiver and have it
checked by qualified personnel before
operating it any further.

To prevent fire, do not cover the ventilation
of the receiver with newspapers, table cloths,
curtains, etc. And dont place lighted candles
on the receiver.

To prevent fire or shock hazards, do not place
vases on the receiver.

0n power sources
- Before operating the receiver, check that the
operating voltage is identical with your local
power supply. The operating voltage is
indicated on the nameplate at the rear of the
receiver.
The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the unit
itself has been turned off.
If you are not going to use the receiver for a
long time, be sure to disconnect the receiver
from the wall outlet. To disconnect the AC
power cord, grasp the plug itself; never pull
the cord.
One blade of the plug is wider than the other
for the purpose of safety and will fit into the
wall outlet only one way. If you are unable to
insert the plug fully into the outlet, contact
your dealer. (Models of area code U, CA only)
' AC power cord must be changed only at the
qualified service shop.

0n placement

' Place the receiver and speakers in a location
with adequate ventilation to prevent heat
buildup and prolong the life of the receiver
and speakers.

Do not place the receiver near heat sources,
or in a place subject to direct sunlight,
excessive dust or mechanical shock.

Do not place anything on top of the cabinet
that might block the ventilation holes and
cause malfunctions.

Although the receiver heats up during
operation, this is not a malfunction. If you
continuously use this receiver at a large
volume, the cabinet temperature of the top,
side and bottom rises accordingly. To avoid
burning yourself, do not touch the cabinet.
Do not place the speakers near heat sources
such as radiators or air ducts, or in a place
subject to direct sunlight, excessive dust,
mechanical vibration or shock.

Do not place the speakers on a soft surface or
in an inclined position, keeping a few
centimeters away from the wall. To abtain a
better bass reproduction, we recommend you
to install the woofer on a solid floor where
the resonance is unlikely to occur.

If the woofer is installed in the center of a
room, the bass could be extremely weakened.
This is due to the influence of the standing
wave of the room. If this happened, move the
woofer away from the center of a room or
eliminate the cause of the standing wave, by
installing a bookshelf on the wall, etc.

0" operation
Before connecting other components, be sure to
turn off and unplug the receiver.