Sony hcd fx 10 owners manual

Page 2

To prevent fire or shock hazard, do not
expose the unit to rain or moisture.

Caution - The use of optical instruments
with this product will increase eye
hazard.

For the customers in the U.S.A

This symbol is irttended to alert the user to
the presence of rrninsulated dartgero

A voltage within the products enclosure that

may be of sufficient magnitude to constitute a risk of

electric shock to persons.
the presence of important operatirtg and

A maintenance (servicing) instructions in the

literature accompanying the appliance.

This symbol is intended to alert the user to

Owner's Record

The model and serial numbers ate located at the bottom
of the unit. Record the serial nrtmber irt the space
provided below. Refer to them whenever you call upon
your Sony dealer regarding this product.

Model No. DAVVFXIO
Serial No.

WARNING

Thrs equipment has been tested artd fourtd to comply
with the limits for a Class B digital device. pursuant to
Part 15 of the FCC thles. These limits are designed to
provide reasonable protection against harmful
rrtterference in a residential installation. This
equrpmertt generates, uses. artd can radiate radio
frequency energy and, if rtot installed and used irt
accordartce vvrth the instructions, may cause harmful
rrtterference to radto communications. However, there
rs no guarantee that interference will rtot occur in a
particular trtstallation. If this equipment does ause
harmful interference to radio or television reception,
which can be detenmned by tuming the equipment off
and on, the user is encouraged to try to correct the
rrtterference by one or more ofthe following measures:

7 Reorient or relocate the receiving antenna (aerial).

7 Increase the separation between the equipment and
receiver.

, Connect the equipment irtto art outlet on a circuit
drfferent from that to which the receiver is
connected.

7 Consult the dealer or an experienced radio/TV
technician for help.

CAUTION

You are cautioned that any changes or modtftcations
not expressly approved in this manual could void your
authority to operate this equipment.

Note to CATV system installer:

Thrs reminder is provided to call the CATV system
installers attention to Article 82040 of the NEC that
provides guidelines for proper grounding and, irt
particular, specifies that the cable ground shall be
connected to the grounding system of the building. as
close to the poirtt of cable erttry as practical.

For the customers in Canada
CAUTION

TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.

Precautions

Safety

- If anything falls into the cabrnet. unplug the urtrt and
have it checked by qualified personnel before
operating it arty frtrtlter.

- The unit is not disconnected from the AC power
source (mains) as long as it '
outlet (mains), even if the urtit itself has been turned
off.

- Unplug the unit from the wall outlet (mains) ifyou do
not intend to use it for an extertded period oftime. To
dtseortnect tlte cord, pull it out by the plug, never by
the cord.

' connected to the wall

Installing

- Allow adequate air circulation to prevent interrtal
heat buildup.

- Do not place the rtnit on surfaces (rugs, blankets, etc.)
or rtear materials (curtains, draperies) that may block
the ventilation slots.

- Do not install the unit near heat sources such as
radiators, or air ducts, or in a place subteet to direct
sunlight, excessive dust, mechartrcal vibratron, or
shock.

- Do not install the unit in an irtcltrted position. It rs
designed to be operated in a horizontal position only.