Sony cmt m 11 c owners manual

Page 1

4

S 0 NY 3-859~82é-11(1)
0

Compact .
Component
System

Operating Instructions____________m
Mode d'emploi_____________

Owner's Record

The model and serial numbeTs are located on the rear panel. Record the serial
number in the space provided below, Refer tn them whenever you call upnn your
Sony dealer regarding this producl.

Model No. _ ___.,, SerlalNo. _______.k

@EE

CMT-M11C

©1997 by Sony Corporation

Page 2

WM

,mu

ZEN

To prevent fire or shock hazard. do not
expose the unit to rain or moisture.

To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.

Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.

Laser component in this product is capable of
emitting radiation exceeding the limit for Class 1.
This appliance is classified
as 3 CLASS I LASER
product. The CLASS 1
LASER PRODUCT
MARKING is located on
the rear exterior.

This caution Label is located inside the unit.

cuss l useamm

'WMWWMI
WW 'mpmmm

ammsa : mu vim-Again-

m m
m .u mrum m

» "rim u mmnu
WW . m um nu KW
mm mm m at... in in WA

~oai-a-emm

ply/mg ; mqummnfauix-fitw.

NOTICE FOR THE CUSTOMERS IN THE
U.S.A.

um wmmmwmw
wwmmmm
mmiamrrmm

w ism loom-nu um mm

This symbol is intended to alert the
user to the presence of uninsulated
"dangerous voltage within the
products enclosure tlmt may be of
sufficient magnitude to constitute a
risk of electric shock to persons.

This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.

CAUTION

The use of optical instruments with this product will
increase eye hazard.

CAUTION

You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.

INFORMATION

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part is of the FCC Rules These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. lf this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:

~ Reoiient or relocate the receiving antenna.

A Increase the separation between the equipment
and receiver.

- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.

- Consult the dealer or an experienced radio/TV
technician for help.

Note on CATV system installer:

This reminder is provided to call CATV system
installers attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.

NOTICE FOR THE CUSTOMERS IN
CANADA

CAUTION:

TO PREVENT ELECl'RlC SHOCK, DO NOT use
THIS POLARIZED AC PLUG WITH AN
EXTENSXON CORD,

RECEPTACLE or OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY lNSERTED TO PREVENT
BLADE EXPOSURE.

The CMT-Mllc consists of the following
components:

CD player CDI»M11C, Tuner MD dock HMD»
M11, Speaker system SAN] l.

U.5. and foreign patents licensed from Dolby
Laboratories Licensing Corporation.