Sony cfd c 626 s service manual

Page 2

Maximum pnwvr output

45W945W

Iower requirements

For CD radio cassette-(order:

Illl, I20, 220, 240V AC M .Iblu 50/) 1.

12 v DC, 3 R20 (sm- D) mounts

For rcmom commander:
3 v DC, 2 R6 (Sim AA) ham-rips

Power consumption

AC ZHW

Bnuery lilt-

For (30 radio moons-rumor

l

FM retarding
Sony SUM-l (NS). nppmx. Ill h

Sony alkaline AMI: nppmx, 15 l-

1

Tape playback
Sony SUM-I (NS): Approx. 7 n
Sony alkaline AMI: approx. n I.

CLASS I LASER PRODUCT
LUOKAN l LASEFILAITE

KIASS I LASERAPPARAT

This Compacl Disc player is classified as a
CLASS I LASER product.

The CLASS I LASER PRODUCT label is
located on the rear exterior.

NOTES ON HANDLING THE OPTICAL PICK~UP
BLOCK OR BASE UNIT

The laser diode in the optical pick-up block may suffer
electrostatic breakdown because of the potential difference

to playback generated by the changed electrostatic load, etc. on clothing
smy SUM-I (N5): nppmx 3 n and the human body.
Sony dlltalineAMlzoppnn. 5 h During repair, pay attention to electrostatic breakdown and

i

also use the procedure in the printed matter which is included
in the repair parts.
The flexible board is easily damaged and should be handled

Dimensions
«ppm. 591 x 249 x aw mm (w/h/tl)

(23 y. x9 mu 9. inches) (incl, prnjming parts) with care

Mm '
approx, 8.7 kg (I9 lb. 3 oz) (incl. balk-rite)

5"" Wm's NOTES ON LASER DIODE EMISSION CHECK
AC power cord (I)

The laser beam on this model is concentrated so as to be

h p. , . . focused on the disc reflective surface by the objective lens in
s n and spot lilcallons an: sublcct to change wIIhIIuI .

mice. the optical pick-up block. Therefore, when checking the laser

diode emission, observe more than 25cm away from the

objective lens.

Remote rommandcr RMT~C777 [ll

CAUTION

Use of controls or adjustments or performance of proce-
dures other than those specified herein may result in
hazardous radiation exposure.

Notes on Chip Component Replacement

- Never reuse a disconnected chip component.

- Notice that the minus side of a tantalum
capacitor may be damaged by heat.

SAFETY-RELATED COMPONENT WARNINGI!

COMPONENTS IDENTIFIED BY MARK & OR DOTIED LINE WITH
MARK A ON THE SCHEMATIO DIAGRAMS AND IN THE PARTS LIST
ARE CRITICAL T0 SAFE OPERATION. REPLACE THESE COMPONENTS
WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN
THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.

_2_