Sharp md x 8 owners manual
This is the 60 pages manual for sharp md x 8 owners manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from sharp md x 8 owners manual (Ocr-read)
Page 1
1 12Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and support- ing structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the ground- ing electrode. 13Non use Periods - The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. 14Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. 15Damage Requiring Service - The appliance should be serviced by qualified service personnel when: AThe power-supply cord or the plug has been damaged; or BObjects have fallen, or liquid has been spilled into the appliance; or CThe appliance has been exposed to rain; or DThe appliance does not appear to operate normally or exhibits a marked change in performance; or EThe appliance has been dropped, or the enclosure damaged. 16Servicing - The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. 17Grounding or Polarization - Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. 1Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. 2Follow Instructions - All operating and use instructions should be followed. 3Water and Moisture - The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. 4Carts and Stands - The appliance should be used only with a cart or stand that is recommended by the manufacturer. ¥ An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. 5Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer. 6Ventilation - The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. 7Heat - The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. 8Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 9Power-Cord Protection - Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, conven- ience receptacles, and the point where they exit from the appliance. 10 Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 11Power Lines - An outdoor antenna should be located away from power lines. ELECTRIC SERVICE EQUIPMENTANTENNA LEAD IN WIRE GROUND CLAMP POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)GROUND CLAMPSGROUNDING CONDUCTORS (NEC SECTION 810-21)ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE NEC - NATIONAL ELECTRICAL CODE S2898A IMPORTANT SAFEGUARDS CAUTION All the safety and operating instructions should be read before the appliance is operated, and should be retained for future reference. Electrical energy can perform many useful functions. This unit has been engineered and manufactured to assure your personal safety. Improper use can result in potential electrical shock or fire hazards. In order not to defeat the safeguards, observe the following basic rules for its installa- tion, use and servicing. FOR YOUR RECORDS For your assistance in reporting this unit in case of loss or theft, please record below the model number and serial number which are located on the rear of the unit. Please retain this information. Model number Serial number Date of purchase Place of purchase SPECIAL NOTES CAUTION RISK OF ELECTRICSHOCK DONOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated Òdangerous voltageÓ within the productÕs enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. *01-1698.6.23, 10:29 AM 1
Page 2
2 0001 PRECAUTIONS 0002 H HH H HGeneral IPlease ensure that the equipment is positioned in a well ventilated area and ensure that there is at least 5 cm of free space along the sides, top and back of the equipment. IDo not use oil, solvents, gasoline, paint thinner or insecticides on the unit. IDo not expose the unit to moisture, to temperatures higher than 140¡F (60¡C) or to extreme low temperatures. IKeep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc.) which generates electrical noise. IHold the AC power plug by the head when removing it from the AC outlet, since pulling the cord can damage internal wires. IRemove the AC power plug from the AC outlet before cleaning. This unit contains dangerous voltages. Do not remove the outer cover, as this may result in electric shock. Refer internal service to your local SHARP service facility. IUse the unit on a firm, level surface free from vibration, and do not place anything on the top of the unit. IIf the unit does not work properly while in use, press the POWER button to turn the power off, then disconnect the AC power cord from the AC outlet. Plug the AC power cord back in, and then press the POWER button to turn the power on. IIf an electrical storm is taking place near you, it is suggested that you disconnect the AC power cord from the AC outlet for safety. IBefore moving the unit, be sure to remove all CDs and MDs from the unit. Then, turn the power off and unplug the AC power cord. If you move the unit with CDs or MDs left in it, they may jam inside the unit, leading to damage. Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage than that which is specified is danger- ous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. H HH H HVolume control The sound level at a given volume setting depends on a combination of speaker efficiency, location and many other factors. It is advisable to avoid exposure to high volume levels, which occur while turning the unit on with the volume control setting up high, or while continually listening at high volumes. H HH H HCondensation Sudden temperature changes and storage or operation in an extremely humid environment may cause condensation inside the cabinet. Condensation can cause the unit to malfunction. Follow the procedure below to eliminate condensation. I II I ICD and MD pickups Leave the power on with no disc in the unit until normal playback is possible (about 1 hour). I II I IRemote control Wipe off any condensation on the transmitter window with a soft cloth before operating the unit. = (Continued) WARNING FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the userÕs authority to operate this equipment. SPECIAL NOTES FOR FCC COMPOSITE DEVICE: This device is a composite system. The digital device component may not cause harmful interference. IIt is the intent of Sharp that this product be used in full compliance with the copyright laws of the United States and that prior permission be obtined from copyright owners whenever necessary. IUS and foreign patents licensed from Dolby Laboratories Licensing Corporation. ISRS technology licensed from SRS Labs. SRS technology holds the following patents: U.S. Patent No. 4,748,669, U.S. Patent No. 4,841,572. I , the SRS Logo and the are registered trademarks of SRS Labs, Inc. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: IReorient or relocate the receiving antenna. IIncrease the separation between the equipment and receiver. IConnect the equipment into an outlet on a circuit different from that to which the receiver is connected. IConsult the dealer or an experienced radio/TV technician for help. Caution - use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. 0049 H HH H HCare of compact discs Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player. IDo not write on either side of the disc, particularly the non-label side. Signals are read from the non-label side. Do not mark on this surface. IKeep your discs away from direct sunlight, heat, and excessive moisture. IAlways hold CDs by the edges. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the center, along the radius. *01-1698.6.23, 10:29 AM 2
Page 2
2 0001 PRECAUTIONS 0002 H HH H HGeneral IPlease ensure that the equipment is positioned in a well ventilated area and ensure that there is at least 5 cm of free space along the sides, top and back of the equipment. IDo not use oil, solvents, gasoline, paint thinner or insecticides on the unit. IDo not expose the unit to moisture, to temperatures higher than 140¡F (60¡C) or to extreme low temperatures. IKeep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc.) which generates electrical noise. IHold the AC power plug by the head when removing it from the AC outlet, since pulling the cord can damage internal wires. IRemove the AC power plug from the AC outlet before cleaning. This unit contains dangerous voltages. Do not remove the outer cover, as this may result in electric shock. Refer internal service to your local SHARP service facility. IUse the unit on a firm, level surface free from vibration, and do not place anything on the top of the unit. IIf the unit does not work properly while in use, press the POWER button to turn the power off, then disconnect the AC power cord from the AC outlet. Plug the AC power cord back in, and then press the POWER button to turn the power on. IIf an electrical storm is taking place near you, it is suggested that you disconnect the AC power cord from the AC outlet for safety. IBefore moving the unit, be sure to remove all CDs and MDs from the unit. Then, turn the power off and unplug the AC power cord. If you move the unit with CDs or MDs left in it, they may jam inside the unit, leading to damage. Warning: The voltage used must be the same as that specified on this unit. Using this product with a higher voltage than that which is specified is danger- ous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. H HH H HVolume control The sound level at a given volume setting depends on a combination of speaker efficiency, location and many other factors. It is advisable to avoid exposure to high volume levels, which occur while turning the unit on with the volume control setting up high, or while continually listening at high volumes. H HH H HCondensation Sudden temperature changes and storage or operation in an extremely humid environment may cause condensation inside the cabinet. Condensation can cause the unit to malfunction. Follow the procedure below to eliminate condensation. I II I ICD and MD pickups Leave the power on with no disc in the unit until normal playback is possible (about 1 hour). I II I IRemote control Wipe off any condensation on the transmitter window with a soft cloth before operating the unit. = (Continued) WARNING FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the userÕs authority to operate this equipment. SPECIAL NOTES FOR FCC COMPOSITE DEVICE: This device is a composite system. The digital device component may not cause harmful interference. IIt is the intent of Sharp that this product be used in full compliance with the copyright laws of the United States and that prior permission be obtined from copyright owners whenever necessary. IUS and foreign patents licensed from Dolby Laboratories Licensing Corporation. ISRS technology licensed from SRS Labs. SRS technology holds the following patents: U.S. Patent No. 4,748,669, U.S. Patent No. 4,841,572. I , the SRS Logo and the are registered trademarks of SRS Labs, Inc. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: IReorient or relocate the receiving antenna. IIncrease the separation between the equipment and receiver. IConnect the equipment into an outlet on a circuit different from that to which the receiver is connected. IConsult the dealer or an experienced radio/TV technician for help. Caution - use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. 0049 H HH H HCare of compact discs Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player. IDo not write on either side of the disc, particularly the non-label side. Signals are read from the non-label side. Do not mark on this surface. IKeep your discs away from direct sunlight, heat, and excessive moisture. IAlways hold CDs by the edges. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the center, along the radius. *01-1698.6.23, 10:29 AM 2