Sharp md m 1 h owners manual

Page 1

1 NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non- rewireable (moulded) plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut-off the mains plug and fit an appropriate type. DANGER: The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock may occur. To fit an appropriate plug to the mains lead, follow the instructions below: IMPORTANT: The wires in the mains lead are coloured in ac- cordance with the following code: Blue : Neutral Brown : Live As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: lThe wire which is coloured blue must be con- nected to the plug terminal which is marked N or coloured black. lThe wire which is coloured brown must be con- nected to the plug terminal which is marked L or coloured red.Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three pin plug. Before replacing the plug cover, make sure that: lIf the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug. lThe cord grip is clamped over the sheath of the mains lead and not simply over the lead wires. IF YOU HAVE ANY DOUBT, CONSULT A QUALI- FIED ELECTRICIAN. SERVICE INFORMATION In the unlikely event of your equipment requiring repair, please contact the dealer or supplier from whom it was purchased. Where this is not possi- ble, please contact the telephone number listed below. You will then be given details of how to obtain serv- ice. - 0345-125387 - Please note; all calls will be charged at local rate. Certain replacement parts and accessories may be obtained from our main parts distributor. WILLOW VALE ELECTRONICS LTD. MANCHESTER 0161-682-1415 READING 01189-876444 In the unlikely event of this equipment requiring repair during the guarantee period, you will need to provide proof of the date of purchase to the repairing company. Please keep your invoice or receipt, which is sup- plied at the time of purchase. lRecording and playback of any material may re- quire consent, which SHARP is unable to give. Please refer par ticularly to the provisions of the Copyright Act 1956, the Dramatic and Musical Performers Protection Act 1958, the Performers Protection Acts 1963 and 1972 and to any sub- sequent statutory enactments and orders. lThis equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. lWhen the ON/STAND-BY button is set at STAND- BY position, mains voltage is still present inside the unit. When the ON/STAND-BY button is set at STAND- BY position, the unit may be brought into opera- tion by the timer mode or remote control. Warning: This unit contains no user serviceable parts. Never remove covers unless qualified to do so. This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period.CAUTION Use the MD micro system only in accordance with the instructions given in this manual and do not at- tempt to interfere with the interlock switch or make any other adjustment as this may result in expo- sure to hazardous radiation. SPECIAL NOTES lUS and foreign patents licensed from Dolby Labo- ratories Licensing Corporation.