Sanyo HTD 5201 Owners Manual

Page 2

. .. PRECAUTIONS

CAUTION

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE, TO
ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS
OR A'I'IEMPT TO GAIN ACCESS TO THE INSIDE OF THE PROD-
UCT.

REFER ALL SERVICING TO QUALIFIED PERSONNEL.

The apparatus shall not be exposed to dripping or splashing.

Do not use where there are extremes of temperature (below 5°C or
exceeding 35°C) or where direct sunlight may strike it.

Because of the DVD/CD players extremely low noise and wide
dynamic range, there might be a tendency to set the volume on the
amplifier unnecessarily high. Doing so may produce an excessively
large output from the amplifier which could damage your speakers.
Sudden changes in the ambient temperature may cause condensation
to form on the optical lens inside the unit If this happens, take out the
disc, leave the unit tor about 1 hour, and then proceed to operate.
When carrying the unit, be sure to remove a disc which may be inside
and turn the poweroff Wait at least 1 0 seconds, then unplug the mains
lead from the AC outlet Carrying the unit with a disc inside may
damage the disc and/or the unit.

Do not install this equipment in a confined space, such as a book case
or built in cabinet.

important Information:

To connect this unit to a TV, TV must have a Video input socket or a Euro-
AV socket. You cannot use an RF input socket or antenna terminal to
connect this unit.

This product incorporates copyright protection technology that is protected
by method claims of certain US. patents and other intellectual propeny
rights owned by Macrovisicn Corporation and other rights owners. Use of
this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only
unless otherwise authorized by Macrovision Corporation. Reverse
engineering or disassembly is prohibited.

IMPORTANT

If the plug supplied with this equipment is not suitable for the socket
outlets in your home it should be cut oil and replaced with the correct
type-

Disposal 0! Plug

lithe non rewireable plug is to be cut off, the removed plug should be
disposed of carefully as there is a shock hazard should the plug be
inserted into a live socket.

Replacing Fuse

The detachable fuse cover must be replaced after changing the fuse.
Only a 3A fuse should be used and should comply with BS1362 and
should carry the ASTA mark ® .

The wires in the mains lead are coloured in accordance with the following
code:

Blue Neutral

Brown Live
The wires in the mains lead must be connected to the terminals in the
plug as follows;

Wire colour Plug terminal marking
Blue N or Black or Blue
Brown L or Red or Brown

Do not connect either wire to the earth terminal
If the mains plug contains a fuse this should be 3A, ifa plug without a fuse
is used the distribution board fuse should not be greater than 5A.

[ The unit is not disconnected trom the mains unless it is unplugged from the AC outlet. J

1