Sanyo DVD X5 Owners Manual

Page 2

CAUTION

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE. TO
ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS
OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PROD-
UCT.

REFER ALL SERVICING T0 QUALIFIED PERSONNEL.

- The apparatus shall not be exposed to dripping or splashing.

- Do not use where there are extremes of temperature (below 5°C or
exceeding 35°C) or where direct sunlight may strike it.

' Because at the DVD players extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplilier
unnecessarily high. Doing so may produce an excessively large
output from the ampllfier which could damage your speakers

- Sudden changes in the ambient temperature may cause oondensatlon
to form on the optical lens inside the unit. If this happens. take out the
disc, leave the unit for about 1 hour. and then proceed to operate.

- When carrying the unit, be sure to remove any discs whlch may be
inside and turn the power off. Wait at least 10 seconds, then unplug
the mains lead from the AC outlet. Carrying the unit with any discs
inside may damage the disc and/or the unit.

- Do not install this equipment in a confined space, such as a book case
or built in cabinet.

- The DVD player is not completely disconnected from the mains when
the Lb/ON button is set to the d) position.

Important Information:

To connect this DVD player to a TV, TV must have a set of AudioNldeo
composite input sockets or a Euro-AV socket. You cannot use an aerial
ten-nlnal to connect this DVD player.

This product incorporates copyright protection technologythat is protected
by method claims cl cenaln U.S. patents and other intellectual property
rights owned by Macrovlsion Corporation and other rights owners. Use oi
this copyright protection technology must be authorized by Macrovlsion
Corporation, and is lntended for home and other limited viewing uses only
unless otherwise authorized by Macrovlsion Corporation. Reverse
engineering or disassembly is prohibited.

IMPORTANT

It the plug supplied with this equipment is not suitable for the socket
outlets in your home it should be cut pit and replaced with the correct
tYPB

Disposal of Plug

If the non rewireable plug is to be out bit, the removed plug should be
disposed at carefully as there is a shock hazard should the plug be
inserted into a I'we socket.

Replacing Fuse

The detachable tuse cover must be replaced after changing the fuse.
Only a 3A fuse should be used and should comply with 351362 and
should carry the ASTA mark ® .

The wires in the mains lead are coloured in accordance with the following
code;

Blue Neutral

Brown Live
The wires in the mains lead must be connected to the terminals in the
plug as lollows;

Wire colour Plug terminal marking

Blue N or Black or Blue

Brown L or Red or Brown
Do not connect either wire to the earth terminal
It the mains plug contains atuse this should be 3A, ll a plug without a fuse
is used the distribution board fuse should not be greater than 5A.

[ The unit is not disconnected trorn the mains unless it is unplugged lrorn the AC outlet.

1