Sanyo DVD SL20 Owners Manual

Page 2

®
§§SE é)

mp

_°"..

AV wee comzcron

CAUTION

REFER ALL SERVICING TO QUALIFIED PERSONNEL.

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE, TO ENSURE CONTINUED SAFETY DO NOT REMOVE ANY
COVERS OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PRODUCT.

- The apparatus shall not be exposed to dripping or splashing.

- No objects filled with liquids, such as vases, shall be placed on the
apparatus.

- Do not use where there are extremes of temperature (below 5°C or
exceeding 35°C) or where direct sunlight may strike it.

- Because of the DVD players extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily high. Doing so may produce an excessively large
output from the amplifier which could damage your speakers.

. Sudden changes in the ambient temperature may cause condensation
to form on the optical lens inside the unit. If this happens, take out the
disc, leave the unit for about 1 hour, and then proceed to operate.

- When carrying the unit, be sure to remove a disc which may be inside
and tumthe poweroff, Wait at least 105eoonds. then unplug the mains
lead from the AC outlet. Carrying the unit with a disc inside may
damage the disc and/or the unit.

- Do not install this equipment in a confined space, such as a book case
or built in cabinet.

- The unit is not completely disconnected from the mains when the col
ON button is set to the 0) position.

- The unit is automatically set to the standby mode after approximately
30 minutes have elapsed under the complete stop mode.

Important Information:

To connect this unit to a TV. TV must have a set of AudioNideo composite
input sockets are Euro-AV socket at least. You cannot connect it to an RF
input socket or aerial terminal of TV.

This product incorporates copyright protection technology that is protected
by method claims of certain U.S. patents and other intellectual property
rights owned by Macrovision Corporation and other rights owners. Use of
this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only
unless otherwise authorized by Macrovlsion Corporation. Reverse
engineering or disassembly is prohibited.

IMPORTANT

It the plug supplied with this equipment is not suitable for the socket
outlets in your home it should be cut oil and replaced with the correct
type.

Disposal of Plug

lithe non rewireable plug is to be cut off, the removed plug should be
disposed of carefully as there is a shock hazard should the plug be
inserted into a live socket.

Replacing Fuse

The detachable fuse cover must be replaced after changing the fuse.
Only a 3A iuse should be used and should comply with 381362 and
should carry the ASTA mark © .

The wires in the mains lead are coloured in accordance with the iollowing
code;

Blue Neutral

Brown Live
The wires in the mains lead must be connected to the terminals in the
plug as lollows;

Wire colour Plug terminal marking
Blue N or Black or Blue
Brown L or Red or Brown

Do not connect either wire to the earth terminal.
If the mains plug contains a fuse this should be 3A, if a plug without afuse
is used the distribution board fuse should not be greater than 5A.

(The unit is not disconnected from the mains unless it is unplugged from the AC outlet. ]

1