Sanyo DC AVD8501 Owners Manual

Page 2

- The apparatus shall not be exposed to dripping or splashing.

- Do not use where there are extremes of temperature (below 5°C or
exceeding 35°C) or where direct sunlight may strike it.

- Because of the DVD players extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily high. Doing so may produce an excessively large
output from the amplifier which could damage your speakers.

- Sudden changes in the ambient temperature may cause condensation
to form on the optical lens inside the unit. If this happens, take out the
disc, leave the unit for about 1 hour. and then proceed to operate.

- When carrying the unit, be sure to remove a disc which may be inside
and turn the poweroff. Wait at least 10 seconds, then unplug the mains
lead from the AC outlet. Carrying the unit with a disc inside may
damage the disc and/or the unit.

- Do not install this equipment in a confined space, such as a book case
or built in cabinet.

- Placing the unit in a well ventilated area is strongly recommended.
Do not place any object on the top of the unit.

Do not block ventilation holes.
The cabinet of the unit warms up when it is used for a long time, but
it is not a malfunction.

CAUTION

THIS PRODUCT CONTAINS A LOW POWER LASER DEVICE, TO
ENSURE CONTINUED SAFETY DO NOT REMOVE ANY COVERS
OR ATTEMPT TO GAIN ACCESS TO THE INSIDE OF THE PROD-
UCT.

REFER ALL SERVICING T0 QUALIFIED PERSONNEL,

Important Information:

To connect this unit to a TV, TV must have a Video input socket or a Euro-
AV socket. You cannot use an RF input socket or aerial terminal to connect
this unit.

This product incorporates oopyrightprotectiontechnology that is protected
by method claims of certain US. patents and other intellectual property
rights owned by Macrovision Corporation and other rights owners. Use of
this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only
unless otherwise authorized by Macrovision Corporation. Reverse
engineering or disassembly is prohibited.

IMPORTANT

If the plug supplied with this equipment is not suitable for the socket
outlets in your home it should be cut off and replaced with the correct
lype-

Disposal of Plug

If the non rewireable plug is to be cutoff, the removed plug should be
disposed of carefully as there is a shock hazard should the plug be
inserted into alive socket.

Replacing Fuse

The detachable fuse cover must be replaced alter changing the fuse.
Only a 3A luse should be used and should comply with 331362 and
should carry the ASTA mark ® .

The wires in the mains lead are coloured in accordance with the following
code;

Blue Neutral

Brown Live
The wires in the mains lead must be connected to the terminals in the
plug as follows;

Wire colour Plug terminal marking

Blue N or Black or Blue

Brown L or Red or Brown
Do not connect either wire to the earth terminal.
If the mains plug contains a fuse this should be 3A, if a plug without a fuse
is used the distribution board fuse should not be greater than 5A.

[The unit is not disconnected from the mains unless it is unplugged from the AC outlet.

1