Rotel RTC 965 OM
This is the 24 pages manual for Rotel RTC 965 OM.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from Rotel RTC 965 OM (Ocr-read)
Page 1
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT. INSERT FULLY. APPLICABLE FOR USA, CANADA OR WHERE APPROVED FOR THE USAGE ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU AU FOND. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is to alert the user to the presence of uninsulated dangerous voltages inside the product's enclosure that may constitute a risk of electric shock. This symbol is to alert the user to important operating and maintenance (service) instructions in this manual and literature accompanying the product. WARNING: There are no user serviceable parts inside. Refer all servicing to qualified ser- vice personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. Heed all warnings and safety information in these instructions and on the product itself. Follow all operating instructions. Clean the enclosure only with a dry cloth or a vacuum cleaner. You must allow 10 cm or 4 inches of unobstructed clearance around the unit. Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation slots. If the unit is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper cooling. Keep the component away from radiators, heat registers, stoves, or any other appliance that produces heat. The unit must be connected to a power supply only of the type and voltage specified on the rear panel of the unit. Connect the component to the power outlet only with the supplied power sup- ply cable or an exact equivalent. Do not modify the supplied cable in any way. Do not attempt to defeat grounding and/or polarization provisions. The cable should be connected to a 2-pin polarized wall outlet, matching the wide blade of the plug to the wide slot of the receptacle. Do not use extension cords. Do not route the power cord where it will be crushed, pinched, bent at severe angles, exposed to heat, or damaged in any way. Pay particular attention to the power cord at the plug and where it exits the back of the unit. The power cord should be unplugged from the wall outlet if the unit is to be left unused for a long period of time. Immediately stop using the component and have it inspected and/or serviced by a qualified service agency if: ¥ The power supply cord or plug has been damaged. ¥ Objects have fallen or liquid has been spilled into the unit. ¥ The unit has been exposed to rain. ¥ The unit shows signs of improper operation ¥ The unit has been dropped or damaged in any way Place the unit on a fixed, level surface strong enough to support its weight. Do not place it on a moveable cart that could tip over. NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna installerÕs attention to Article 820-40 of the NEC. This provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the build- ing, as close to the pint of cable entry as practical. See installation diagram. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installa- tion. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause interfer- ence to radio or TV communications. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause interfer- ence to radio or television reception, which can determined by turning the equipment off and on, try to correct the interference by one or more of the fol- lowing measures: ¥ Reorient or relocate the receiving antenna. ¥ Increase the separation between the unit and the television tuner. ¥ Connect the unit to an outlet on a different electrical circuit. ¥ Consult your authorized Rotel dealer for assistance. ELECTICAL SERVICE BOX GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ARTICLE 250, PART H) GROUNDING CONDUCTORS (NEC SECTION 810-20) ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) ANTENNA LEAD IN WIRE GROUND CLAMP ANTENNA GROUNDING ACCORDING TO NATIONAL ELECTRICAL CODE INSTRUCTIONS ARTICLE 810: "RADIO AND TELEVISION EQUIPMENT"
Page 2
RTC-965 3 Figure 1: Controls and Connections REMOTE SENSOR 1 2 3 4 BACK 5 6 ENTER 7 8 9 0 SWITCHED 100W MAX VIDEO 3 VIDEO 2 AUX/ VIDEO 5 TV MONITOR VIDEO 4 PHONO CD TAPE1IN OUT TAPE 2 MONIN OUT AUX 5 4 3 2 VIDEO DIGITAL INPUT GND FRONT CENTER PREOUTSUB WOOFER PREOUT AM LOOP FM 75W REMOTE EXT IN REAR WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. CAUTIONRISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUEÐNE PAS OUVRIR SUBWOOFER + Ð REAR + Ð CENTER + Ð POWER SURROUND SOUND TUNER PREAMPLIFIER RTC-965 5.1 CH INPUT WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. TREBLE BALANCE STANDBY VIDEO 2 VIDEO 1 TAPE 2 MONITOR TAPE 1 TUNER PHONOVIDEO 3 CD SURROUND SOUND TUNER PREAMPLIFIER MODEL NO. RTC-965 RTC-965 ANTENNA STANDBY VIDEO 4AUX/ VIDEO 5 SPEAKER MODE MENU DYNAMIC RANGE STEREO 3 STEREO PRO-LOGIC5.1 CH INPUT DSPVIDEO LABELSVIDEO 1 REC MASTER VOLUME BASSFREQUENCY DIRECT MEMORY MONO BAND < TUNING > S-VIDEO COMPOSITE LR LR LR VIDEO 1 PLAY VIDEO 1 REC 5.1 CH OUTPUT LRAC INPUT 34 SOURCEVID4AUXVIDEO 3VIDEO2 VIDEO1REC MPEG dtsRBDS RDS RT EON TP TA PTY TAPE2M ST TUNED AUTO MEMORY PRESET Digital Pro Logic 3 Stereo DSP MODE 5.1 CH D. RANGE SLEEP OSDOPTICAL1COAXIAL2 8 9 10 11 12 13 14 15 16 17 25 19 21 20 22 7 24 23 18 33 27 26 28 29 30 31 32 34 39 35 37 36 38 40 6 2 5 3 1 4