Pyle pldcp 12 owners manual

Page 1

3 To Charge the capacitor: 1. Make Capacitor positive terminal connections with amplifier and tighten the bolt. Do not over-tighten the bolts! Caution: Stripped terminals are not covered under the capacitors warranty. 2. Connect the ground cable with battery, amplifier, then refer to the attached drawing. 3. Place the supplied charging bulb or resistor between the positive terminal of the capacitor and the batterys positive terminal. Do this for 30 seconds or until the charging bulb goes out. Caution: The charging bulb will get hot! 4. Immediately after the charging process, take out the charging bulb from the connecting wire. And connect the positive cable of the battery directly to the positive terminal on the capacitor. DISCHARGING THE CAPACITOR: WHEN YOU WANT TO MOVE THE CAPACITOR FROM ORIGINAL INSTALLED CAR AUDIO SYSTEM, YOU MUST FIRST FOLLOW DISCHARGING PROCESS AFTER TAKING OUT THE CAPACITOR FROM THE CAR AUDIO SYSTEM. To Discharge the capacitor: With batte ry power disconnected, place the light bulb or resistor across the capacitors positive and negative terminals until light goes out or for three minutes if using a resistor. 4 Multiple Capacitor Wiring Diagram: LIMITED WARRANTY One Year Warranty from the date of purchase. WARNING !! THIS POWER CAPACITOR MAY EXPLODE AND CAUSE SERIOUS INJURY IF ABUSED OR CONNECTED IMPROPERLY. PLEASE REFER TO THE INSTRUCTIONS CONTAINED IN THIS MANUAL FOR CORRECT MOUNTING, CHARGING/DISCHARGING AND WIRING CONNECTION FOR THIS CAPAPCITOR PRIOR TO INSTALLATION.