Primare c 31 owners manual
This is the 7 pages manual for primare c 31 owners manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from primare c 31 owners manual (Ocr-read)
Page 1
>Preface ii COPYRIGHT AND ACKNOWLEDGMENTS Copyright © 2001 Primare Systems AB. All rights reserved. Primare Systems AB Idavägen 17D SE-352 46 Växjö Sweden The information in this guide is believed to be correct as of the date of publication. However, our policy is one of continuous development and so the information is subject to change without notice, and does not represent a commitment on the part of Primare Systems AB. Primare is a trademark of Primare Systems AB. All rights reserved. All other product names are trademarks or registered trademarks of their respective owners. This guide was produced by Human-Computer Interface Ltd, http://www.interface.co.uk
Page 2
> 1 Introduction Welcome to the Primare C31 Remote Control. This booklet explains how to use the C31 to operate all the units in your Primare system. WELCOME TO THE C31 REMOTE CONTROL The elegant C31 Remote Control allows you to operate all the units in your Primare system with a set of simple and logical push button controls. Ergonomic design The C31 is designed to be extremely comfortable to hold, and its weight makes it easy to balance it in the palm of a hand while operating the controls. Its durable construction ensures that it will continue to operate perfectly for many years to come. Future proof The C31 has been designed so that it can be upgraded to control future products in the Primare range, not yet introduced, by the simple operation of adding an upgrade chip. CODE BUTTON The CODE button allows you to select which Primare unit is controlled by the C31 Remote Control. Pressing the CODE button switches between the following three modes, as shown by the CODE light: CODE light Controls Off CD players, P30/SP30 Processor, tuners, and integrated amplifiers. On DVD players, P30/SP30 Processor, tuners, and integrated amplifiers. Flashing CD players, PRE30 Preamplifier, and tuners. Note: After a short delay the CODE light dims to conserve the batteries. It will light up again as soon as you operate any of the buttons. DISABLING PRE30 MODE If you do not have a PRE30 Preamplifier you can disable PRE30 mode as follows: -Remove the C31 batteries, as described below. -Replace the batteries while holding down the STBY button. To restore PRE30 mode: -Remove and then replace the batteries while holding down the DIM button.