Primare c 30 owners manual
This is the 6 pages manual for primare c 30 owners manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from primare c 30 owners manual (Ocr-read)
Page 1
>Preface ii COPYRIGHT AND ACKNOWLEDGMENTS Copyright © 2000 Primare Systems AB. All rights reserved. Primare Systems AB IdavŠgen 17D SE-352 46 VŠxjš Sweden The information in this guide is believed to be correct as of the date of publication. However, our policy is one of continuous development and so the information is subject to change without notice, and does not represent a commitment on the part of Primare Systems AB. Primare is a trademark of Primare Systems AB. All rights reserved. All other product names are trademarks or registered trademarks of their respective owners. This guide was produced by Human-Computer Interface Ltd, http://www.interface.co.uk
Page 2
> 1 Introduction Welcome to the Primare C30 Remote Control. This booklet explains how to use the C30 to operate all the units in your Primare system. WELCOME TO THE C30 REMOTE CONTROL The elegant C30 Remote Control allows you to operate all the units in your Primare system with a set of simple and logical push button controls. Ergonomic design The C30 is designed to be extremely comfortable to hold, and its weight makes it easy to balance it in the palm of a hand while operating the controls. Its durable construction ensures that it will continue to operate perfectly for many years to come. Future proof The C30 has been designed so that it can be upgraded to control future products in the Primare range, not yet introduced, by the simple operation of adding an upgrade chip. MODE BUTTON To operate a processor or amplifier the MODE light should be off. If necessary press the MODE button to turn it off. To operate a DVD or CD player, or an FM tuner, press the MODE button. The green MODE light will be illuminated to indicate that the source control keys are active. Press the MODE button again to switch the remote control back to operating your processor or amplifier. Note that after a short delay the MODE light dims to conserve the batteries. It will light up again as soon as you operate any of the buttons. CHANGING THE BATTERIES If the MODE light does not illuminate clearly when you press the MODE button you should replace the C30Õs batteries. To do this proceed as follows: ¥Remove the four screws on the back panel of the C30, using a small cross point precision screwdriver. ¥Gently lift up the back panel and put it to one side. ¥Remove the two batteries from the battery compartment and replace with two alkaline size AAA 1.5 Volt batteries, taking care to fit them with the correct polarity as marked on the inside of the battery compartment. Do not touch the circuit board as you may damage the sensitive electrical components. Please be considerate to the environment when disposing of the old batteries. ¥Replace the back panel and secure it in place using the four screws.