Pioneer pl 514 owners manual

Page 1

STEREO TURNTABLE

L-514

OPERATING INSTRUCTIONS KUT

IMPORTANT NOTICE

The serial number for this equipment is --
located on the rear.
;- Please write this serial number on your___
I: enclosed warranty card and keep in a
secure area. This is for your security.

fir

Mclallikc vinyl

WARNING: TO PREVENT FIRE 0R SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR ---

GDPIONEER MOISTURE

[Ill llllllllll

Page 2

Thank you for buying the Pioneer PL-514 stereo
turntable. The PL-514 is a high-performance CONTENTS
belt-drive turntable which em lo 3 an auto- - -
return mechanism. Be sure to mid 3tlhese OPFR- 2:232:11: :zcimdge """"""""" :
ATING INSTRUCTIONS before commencmg """"""""""
operation. Adjusting the Tonearm .................. 4
Connections .......................... 5
Maintenance .......................... 5
Panel Facilities and Operation ............. 6
Troubleshooting ....................... 7
Specifications ......................... 8
A'I'I'ACHING THE CARTRIDGE
You can attach any cartridge to this turntable Screws- .
weighing between 4g and 10g on condition that 4?
only the accessory headshell is used with it. Follow Washers -¢

the procedure outlined below for attaching the

cartridge to the headshell.

1. Take out the headshell, cartridge mounting madman
screws, nuts, washers and small-sized screwdriver
from the accessory box.
The screws come in three different lengths so Cartridge
choose the screws according to the height of the
cartridge you intend to attach.

2. The terminals on the accessory headshell are Stylus cover
aligned as shown in Fig. 1. Check the location

and polarity of each of the cartridges terminal . _ . .

pins and then connect the lead wires, taking care 4. Adjust the posmon of the cartndge so that the
not to get the polarities mixed up. stylus and the connector section of the headshell
are 49mm apart and tighten up the screws. Make

$275.} older he on connect the lead wires to the sure that the cartridge does not tilt to one side
no a w n y . .
cartridge. If the lead wire lugs are loose, use a pair of When you attaCh lt (see Flg' 3)

tweezers or a similar device to push in the end lightly.

Terminal pin

Fig. 2

Fig. 3

ATTACHING HEADSHELLS NOT MADE BY
PIONEER

You can attach headshells made by other com-
panies as long as the coupling portion has the same

Right channel (red)
Right channel ground (green)

Leftchannol (mm-m dimensions as the headshell supplied with your

Lellch'me'flmund lb'uel * PL-514. However, you should check whether the

Fig. 1 terminals on the other headshell are aligned in the

same way. When attaching, make sure that you do

3. Attach the cartridge lightly to the headshell not neglect to carry out the four steps described
using the screws, nuts and washers (Fig. 2). above.