Pioneer ct 670 owners manual

Page 1

STEREO CASSETTE TAPE DECK

' - STEREO-KASSETI'ENBANDGERAT
Opera "9 Instructions PLATINE CASSETTE STEREO

Bedienungsanleitung REGISTRATORE A CASSETTE STEREO

Mode demploi
Istruzioni per Iuso -

English; Page 1
Deutsch; Selle 7
Franoais; Page
Italiano; Pag. 1 5

mlm

re- 55 l l-__I> :l:
__ 1) . . .fi. .
eta» »| all» W or
Thank you for buying this Pioneer product. LINE VOLTAGE SELECTOR SWITCH
Please read through these operating instructions so you will Only multi-voltage models are provided with this
know how to operate your model properly. After you have switch. U.S., Canadian, European, U.K., and Australian
finished reading the instructions, put them away in a safe models are not provided with this switch.
place for future reference. Before your model is shipped from the factory, the switch is set to
In some countries or regions, the Shape Of the I30W9r PIUQ and the power requirements of the destination; nevertheless, you should
power outlet may sometimes differ from that shown in the ex- check that it is set properly before plugging the power cord into the
planetary drawings. However, the method of connecting and AC outlet.
operating the unit is the same. 1- Disconnfi:t the power Cord-

2. Use a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area.
WARNING: To PREVENT FIRE 0R SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

FRANCAIS

IMPORTANT NOTICE
[For U.S. and Canadian models]

The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure area. This is for your security.

Volls

Screwdriver

This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/889/EEC and
82/499/EEC.

GD PIONEERQ

i
i
l

Page 2

SAFETY INSTRUCTIONS

READ INSTRUCTIONS - All the safety and
operating innructions should be read berm the
appliance is operated.

ltErAIN INSTRUCTIONS - The operating instruc-
tion; should be retained for tutors reference

NEED WARNING - All warnings on the appliance
and in the operating instructions should be adhered

to.

FOLLOW INSTRUCTIONS - All operating and use
instruction: should be followed.

WATER AND MOISTURE 7 The appliance should
not be used near water - tor example, near a
bathtub, washbowl, kitchen sink, laundry tub, in a
wet basement, or near a swimming pool. etc.

LOCATION - The appliance should hit installed in a
stable location.

WALL OR CEILING MOUNTING v The appliance
should not be mounted to a wall or ceiling.

VENTILATION - The appliance should be situated at)
that its location or position does not interfere with
its proper ventilatinn. For example, the appliance
should not be situated on a bed, sera, rug, or
similar surilce that may block the ventilation opens
ings; or, placed in a built-in installation, such as a
bookcase or cabinet that may impede the new of
air through the ventilation openings,

HEAT - The appliance should be situated ley horn
heat sources such as radiators. hear registers,
stoves, or other appliances (including amplifiers)
that produce heat.

POWER SOURCES - The appliance should be con-
nected to a power supply only at the type describ-
ed in the operating instructions or as marked on the
appliance.

POWER-CORD PROTECTION - Powersupply cord!
should be round so that they are not likely to he
walked on Or pinched by items placed upon or
against them. Paying particular attention to cords
at plugs, convenience receptacles, and the point
where they exit train the appliance,

POLARIZATION - it your purchased product is pro-
vided with a polarized power plug, please read the
renewing instructions This product is equipped
with a polarized alternating current line plug (a plug
having one blade wider than the other), This plug

POWER LINES - An outdoor antenna should be
located away irom power lines.

NONUSE PERIODS - The pcwar cord DI the ap-
plianca should be unplugged from the outlet when
lert unused ior a long period or time.

OBJECT AND LIQUID ENTRY A Care should be
taken so that Dhiacts dd not tell and liquids are not
spilled into the enclosure through openings.

DAMAGE REQUIRING SERVICE 7 The appliance
should be serviced by Pioneer authoritad service
center or qualified service personnel when:

. The power-supply cord or the plug has been
damaged: or

' Obiects have fallen, or liquid has been spilled into
the appliance: or

' The appliance has been exposed to rain; or

0 The appliance does not appear t0 operate normally
or exhibits a marked change in performance: or

- The appliance has oeen dropped; or the enclosure
damaged.

SERVICING A The user should not attempt to service
the Ipplianl beyond that described in the
operating instructions. For all other servicing, con-
tact the nearest Pioneer authorized service center.

smite
tnrisncr
concucrons r

41(qu
olscnrlnct dun c

OUTDOOR ANTENNA GROUNDING - If an

outside antenna is connected to the antenna
terminal, be sure the antenna system is
grounded so as to provide some protection
against voltage surges and built up static
charges.
In the U.S.A, section 310 of the National Elec-
trical Code, ANSI/NFPA Nat 70-19541 pros
vides information with respect to proper
grounding or the mast and supporting struc-
ture, grounding of the lead-in wire to an anten-
na discharge unit, size or grounding conduc-
tors, location of antennardischarge unit, con-
nection tp grounding electrodes, and re-
auiremems tor the grounding electrode. See
Fig. A.

a) Use No. 10 AWG (5.3 mm)
copper. No. a AWG 18.4
mml aluminum, No. 17
AWG (1.0 mrrl'l copper-
olad steel, teronrs wire, or
larger as ground wire.

bl Secure antenna lead-in and
ground wires to house with
standorr insulators spaced
rrom 4 rest .22 metersl to
6 rest (1.33 metersi apart.

cl Mount antenna discharge
unit as closely as possible to
where leadrin enters house.

sung orr
tusuumls o

ANIiNNA
LEAD tn WllE

ro urinrdlitantimik d) Useiurrlperwire notsmaller
rummts or Wabucr

than No.6 AWG 3.3 mml
copper or equivalent when
separate antennarground-
ing electrode is used.

will lit into the power outlet only one way. This isa either turmeric:
safety restore. lr you are unable to insen the plug WW 5333:
tullv into the outlet, try reversing the plug. it the
plug should still rail to nt, Contact your electrician
to replace your obsolete outlet, Do not defeat the PM 5mm a
solely purpose or the polarized plug. 3:031:36 girgflbsgsrw
CLEANING _ The appliance should be cleaned only onwumrm

ennunp c strcrrtcot

with a polishing cloth or a soft dry cloth. Never
clean with furniture wax, benzirte, insecticides or
other volatile liquids since they may corrode the

nouotuc t
ruurtn d I

lll v
to: doors at

cabinet.

AL 5
FIG A u ME: SECUON aunt in

IMPORTANT 1

The lightning flash with arrowhead. within an
equilateral triangle, is intended to alert the user of the
presence at uninsulated "dangerous Vultage" within the
products enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.

RISK OF ELECTRlC OCK
DO NOT OPEN

CAUTION:

T0 PREVENTTHE RISK OF ELECTRIC SHOCK. DO
NOT REMOVE COVER IOR BACK]. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVIC<
ING TO QUALIFIED SERVICE PERSONNEL

The exclamation point within an equilateral triangle is
intended to alert the user at the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.

IMPORTANT 2

it the apparatus is fitted with AC mains power outlerls),
see REAR PANEL FACILITIES for convenient connec-
tion at additional Hi-Fi companentlsl. Make all connec-
tions to the AC autletlsl and the signal terminals first.
Connect the plug to the wall socket last, make sure that
the power switch is off, Disconnect the wall plug when
the equipment is not in lrcgulsrl use, 9.9. when on
vacation.

FOR USE IN THE UNITED
KINGDOM

WARNING: This plug must only be connected to
electronic apparatus equipped with suitable
sockets.

It not, out o" the plug and in an appropriate type
in accordance with the instructions below.

the cube" plug must be disposed or as an elec-
trical shock hazard could exist It connected to a
socket outlet.

The wires in this mains lead are coloured in accordance
with the {allowing code:

Blue: Neutral

Brown: Live
As the colours of the wires in the mains lead at this ap-
paratus may not correspond with the coloured marking
identirying the terminals in your plug proceed as
iollnws:
The wire which is caloured blue must be connected to
the tarminal which is marked with the letter N or cul-
cured black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or col-
oured red,

2