Pioneer ct 1070 r owners manual

This is the 40 pages manual for pioneer ct 1070 r owners manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.

Page: 1 / 40
pioneer ct 1070 r owners manual

Extracted text from pioneer ct 1070 r owners manual (Ocr-read)


Page 1

gTEREg CASSETTE TAPE DECK"

- - TERE-KASSEnENBANDGERAT

Operating Instructions MAGNETOPHONE A CASSETTE STEREO
Mode demploi

Islruzioni per IUSO c T _ 1 o 7 o n

Thank you for buying this Pioneer product.

Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference

In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the ex~
planatory drawings. However, the method of connecting and
operating the unit is the same.

WARNING: To PREVENT FIRE on SHOCK HAZARD. LINE VOLTAGE SELECTOR SWITCH

DO NOT EXPOSE THIS APPLIANCE T0 RAIN 0R MOISTURE Only multi-voltage models are provided with this switch. U.S..
Canadian, Europeanl U.K., and Australian models are not pro-
vided with this switch.
The line voltage selector switch is on the rear panel. Before your
model is shipped from the factory, this switch is set to the power re-

ENGLISH

3:
U
U)
I-
=
I.
D

|MPORTANT NOTICE quirements of the destination. Check that it is set properly before
plugging the power cord into the AC outlet. If the voltage is not pro-

[FOI U .S. and Canadian MOdEIS] perly set or if you move to an area where the voltage requirements dif-

The serial number for this equipment is located on the rear fer, adjust the selector switch as follows.

panel. Please write this serial number on your enclosed war- 1- Disconnect the power cord.

2. Use a medium-size screwdriver.

{Y 3. Insert the screwdriver into the groove on the voltage selector, and
adjust so that the tip of the arrow points to the voltage value of

your area.

ranty card and keep it in a secure area. This is for your securi-

[For Canadian model]

CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD.
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

ATTENTION: POUR PREVENIR LEs CHOCS ELEC-
TRIOUES NE PAS UTILISER CETI'E FIGHE POLARISEE AVEC
UN PROLONGATEUR UNE PRISE DE COURANT ou UNE
AUTRE SORTIE DE COURANT, SAUF sr LES LAMES PEUVENT
ETRE INSEREES A FOND sANs EN LAISSER AUCUNE PARTIE
A DECOUVERT.

Medium-size screwdriver

This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/8$/ EEC and
82/499/EEC. "

Mploweerw

Page 2

READ INSTRUCTIONS - All the satetv and
operating instructions should be read before the
appliance is operated.

REI'AIN INSTRUCTIONS - The operating instruo
rlons should be retained for turure reference.
NEED WARNING - AII wimirlgs on the appliance

and in the operating instructions should baadhered

to.

FOLLOW INSTRUCTIONS - All operating and use
instructions should be followed.

WATER AND MOISTURE - The appliance should
not be used near water - for example, near a
bathtub, washoowl, kitchen sink, laundry tub, in a
wet bmmant, or near a swimming pool, etc.

LOCATION - The appliance should be installed in a
stable location.

WALL OR CEILING MOUNTING - The appliance
should not be mounted to a wall or ceiling.

VENTILATION - The appliance should be situated to
that its location or position does not interfere with
its proper ventilation. For example, the appliance
should not be situated on a bed, sols, rug, or
similar surface that may block the ventilation open»
inge; or, plaoed in a built-in installation. such as a
bookcase er cabinet that may impede the flow or
air through me ventilation openings.

HEAT - The Ioplilnoe should be situated away from
heel source: such as radiators, heat registers,
stoves, or other appliances (including amplifiers)
that produce heat.

POWER SOURCES - The appliance lhould be con-
nected to a power supply onry of the type describ-
ed in the operating instructions or as marked on the
appliance.

POWER-CORD PROTECTION - FcMrarrsuDPchnrds
should be routed so that they are not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to oordr
at plugs, convenience receptacles, and the point
where they exit "cm the appliance.

POLARIZATION - If your purchased product is pro-

SAFETY INSTRUCTIONS

POWER LINES - An outdoor antenna should be
located away from primer lines.

NONUSE PERIODS - The power cord of the ap-
pliance should be unplugged from the outlet when
loft unused for a long period of time.

OBJECT AND LIQUID ENTRY - Care should be
when so thlt object: do not fall and liquids are not
spilled into the enclosure through openings.

DAMAGE REQUIRING SERVICE The appliance
should be serviud by Pioneer authorized service
center or qualified service personnel when:

- The powarvsupply cord or the plug has been
damaged: or

I Objecs have fallen, or liquid has been spilled into
the appliance; or

3 The appliance has been exposed to rain; or

0 The appliance does not appear to operate normally
or exhibits a merited cnrnge in perlormanoe; or

- The appliance has been dropped; or the enclosure
damaged.

SERVICING - The user should not attempt to service
the appliance beyond that described in the
operating instructions. For all other servicing. con-
tact the nearest Pioneer authorized service center.


Iowa unis

SEnvlCE
Eroturtcs
conoucrons ,


OUTDOOR ANTENNA GROUNDINB - It an

outside antenna is connected to the antenna
terminal. be sure the antenna system is
grounded so as to provide some protection
against voltage surges and built up static
charges.
In the U.S.A. section 310 OI the National Elecv
trioal Code, ANSI/NFPA No. 7049841 pro-
vides inlennation with respect to proper
grounding at the mast and supporting strucs
lure, grounding oi the lead-in wire to an anten-
na discharge unit, slze oi grounding conducs
tors, location or antenna-discharge unit, con-
nection to grounding electrodes, and re-
quiremsnts tor the grounding electrode. See
Fig A.

al Use No. II) AWG (5.3 mml
copper, No. B AWG 13.4
mmll aluminum. Nee I7
AWG (1.0 mm) copper-
clad steel, bronze wire. or
larger as ground wire.

it) Secure antenna leadin and
ground wires to house with
stand-oh insulators spaced
from 4 reel ll .22 meters) to
6 feet (LE metersl «part.

c) Mount antenna discharge
unit as closely as possible to
where leudrin enters house.

sumo arr
wsuwoas o

ANTENNA
morn writs

video with a polarized power plug, please read the
tellowing instructions. This product is equipped
with a polarized alternating curlent line plug ll plug
having one blade wider than the other). This plug
will fit into the power outlet only one way. This is a
safety feature If you are unable to insert the plug
fully into the outlet. try reversing the plug, It the
plug should still fail to fit, contact your electrician
to replace your obsolete outlet. Do not defeat thu
safety purpose or the polarized plug.

CLEANING - The appliance should be cleaned only

l3.ii.lf.'l§$.$.l§§flér di Use iumperwire not smaller

than No.6 AWG "3.3 mml
copper or equivalent when
separate antenna-ground-
ing electrode is used.


_ ammo
DISEMAIGE uurr r

owunn
will i a

"h- cnauno
women SERVICE , yr cums
GRoUNDING ELELrnonEsYstm '
lep mm... met-l «no out

. . . cricuuownsttctkooi
with a polishing olorh or a sort dry cloth. Never mm . 513?:Ermn'wm
clean with Iumiture wax, benzine, insecricides or more :, emulliolr SEE
other volatile liquids since they may corrode the nah i; $233555... ..,
cabinet.

IMPORTANT 1

The lightning flash with anowlread, within an
equilateral triangle, is intended to alert the user of the
presence of uninsulatad "dangerous voltage within the
product's enclosure that may be or sufficient magnitude
to constitute a risk of electric shock to persons.

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION:

To FREVENTTHE RISK OF ELECTRIC SHOCK. DO
NOT REMOVE COVER (OR BACK). N0 USER-
SERVICEABLE PARTS INSIDE. REFER SERVle
ING TO QUALIFIED SERVICE PERSONNEL.

The exclamation point within an equilateral triangle is
intended to alert the user of the presence of imporlant
operating and maintcntnce (scruicingi instructions in
the literature accompanying the appliance.

IMPORTANT 2

II the apparatus is fitted with AC mains power outletlsl,
see REAR PANEL FACILITIES Ior convenient conne
tion at additional Hi-fi componentlsl. Make all connec-
tions to the AC outletlsl and the signal terminals first.
Connect the plug to the wall socket last, make sure that
the power switch is off. Disconnect the wall plug when
the equipment is not in (regular) use, 9.9. when on
Vacation.

FOR USE IN THE UNITED
KINGDOM

WARNING: This plug must only be connected to
electronic apparatus equipped with suitable
sockets.

If not, out on the plug and fit an appropriate type
'In accordance with the instructions below.

The cube" plug must be disposed 0' al an elec-
trical shock hazard could exist if connected to a
socket outlet.

The wires in this mains lead are coloured in accordance
with the ioliowing code:

Blue: Neutral

Blown: Live
As the colours of the wires in the mains lead of this aur
paratus may not correspond with the coloured marking
idenrirying the terminals in your plug proceed as
Iullows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or cola
outed black.
The wire which is coloured brown must be connected to
the terminal which marked with the letter L or col-
oured red.

2