Pioneer ct 1060 w owners manual

Page 1

Operating Instructions
Bedienungsanleitung

Mode demploi
Istruzioni per Iuso

English; Page 1
Deutsch; Seite 13
Francois; Page 23
ltaliano; Pag. 33

STEREO DOUBLE CASSETTE TAPE DECK
STEREO- DOPPELKASSE'ITENBANDGERAT
DOUBLE MAGNETOCASSETI'E STEREO
DOPPIA PIASTRA DI REGISTRAZIONE A
CASSETTE STEREO

CT-IDEDW

Photograph shows BLACK finished model.

82/ 499/ EEC. "

This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/ 889/ EEC and

Thank you for buying this Pioneer product.

Please read these operatinginstructions thoroughly, so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference.
For the sake of convenience, these operating instructions are based
on the model HEM. and they can be used for the HB, HP, KU, KC, D
and DIG models.

The differences between the models are given below.

HEM model:

For Europe excluding U.K. (HEM 'stamped on packing case): Power
line voltage is AC 220 volts.

HB model:

For U.K. ('HB' stamped on packing case): Power line voltage is AC
240 volts.

HP model:

For Australia ('HP stamped on packing case): Power line voltage is
AC 240 volts.

KU and KC models:

For U.S.A. and Canada ('KU' or KC' stamped on packing case):
Power line voltage is AC 120 volts.

D and DIG models:

For destinations excluding above lD or D/ G' stamped on packing
case): A 3~point (120 V/220 Vl240 VI voltage selector switch is pro-
vided.

NOTE:
Depending upon the model, the design of the power plug and the
power outlet differs.

The line voltage selector switch is located on the rear panel of the
unit. Please check that it is set properly before plugging the power
cord into an outlet, lfiI is not set properly, change the setting ac-
cording to the LINE VOLTAGE SELECT/ON (D and BIG models
only).

IMPORTANT NOTICE (For KU and KC models)

The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep in a secure place. This is for your security.

WARNING: TO PREVENT FIRE 0R
SHOCK HAZARD, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.

LINE VOLTAGE SELECTION
(D and BIG models only)

Before your model is shipped from the factory, the switch is set to the

power requirements of the destination; nevertheless, you should

check that it is set properly before plugging the power cord into the

AC outlet.

1. Disconnect the power cord.

2. Provide yourself with a medium size screwdriver.

3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area. '

Screwdriver

HEM (for Europe excluding U.K.), HB (for U.K.), HP (for
Australia), KU (for U.S.A.) and KC (for Canada) models are not
provided with a LINE VOLTAGE SELECTOR switch.

Q} PIONEERE

D
Z
S.
.1
E

Page 2

SAFETY INSTRUCTIONS

READ INSTRUCTIONS - All the safety and
operating instructions should be read before the
appliance is operated.

RETAIN INSTRUCTIONS - The operating initruc-
tions should be mined for future reference,
NEED WARNING - All wamlngs on the appliance

and in the operating instructions should be adhered

to.

FOLLOW INSTRUCTIONS - All operating and use
instructions should be followed.

WATER AND MOISTURE - Th! appliance should
not be used near water -- for exempts, near a
bathtub, washbowl, kitchen sink, laundry tub, in a
wet basement, or near a swimming pool, etc.

LOCATION - The appliance should be inauiled in a
stable location.

WALL OR CEILING MOUNTING - The appliance
Ihcruld not be mounted to a wall or ceiling

VENTILATION - The appliance should be situated so
that its location or position does not interfere with
its proper ventilation. For example. the appliance
should not be situated on a bad, sofa, mg, or
si ilar eurtncc that rrtrry block the uentilau'on open
lugs; or, placed in a builtvin inmllation, such as a
bookcase or cabinet that may impede the flow of
air through the ventilation openings,

HEAT - The appliance should be situated away from
heat sources such as radiators, haat registers,
stoves, or other appliances (including amplifiersl
that produce heat.

POWER SOURCES - The appliance should be con-
nected to a power supply only of the type describ-
ed in the operating instructions or asmarked on the
appfiancu.

rowan-coup Pnot'scrlcrN v Power-supply cords
Ihauld be routed an that they in not likely to be
walked on or pinched by items placed upon or
against them, paying particular attention to cards
at plugs, convenience receptacles, and the point
where they exit from the appliance.

POLARIZATION - Ir your purchased product is pro
vided with a polarized power plug, please read the
iollowing instructions. This product it equipped
with a polarized altenroting current lino plug (a plug
having one blade wider than the other). This plug
will tit into the power outlet only one wary. This in
salary testing. It you are unable to insert tha plug
fully into the outlet, try reversing the plug It the
plug should still fail to fit, contact your electrician
to replace your obmleto outlet. Do not defeat the
safety purpose of the polarired plug,

CLEANING - The appliance should be cleaned only
with a Dolilhing cloth or a suit dry cloth. Never
clean with lumltun Wu, Deming, insecticidos or
other volatile liquids since they may corrode the
cabinet.

POWER LINES - An outdoor antenna should be
located away trorn power lines.

NONUSE PERIODS - The power cord of the ap-
pliance should be unplugged irom the outlet when
lat! unused tor a long period of time.

OBJECT AND LIQUID ENTRV - Care should be
taken do that cbjocta do not fall and liquids are not
spilled into the enclosure through openings.

DAMAGE REQUIRING SERVICE - The appliance
should be serviced by Pioneer authorized service
center or qualified saruica parsonnal when:

- The pwarGuDPlY cord or the plug has been
damaged; or

. Objects have touch, or liquid has been spilled into
the appliance: or

0 The appliance has been exposed to rain; or

n The applianoc does not appear to operate normally
or exhibits a marked change in performance; or

0 The appliance has been dropped; or the enclosure
danragod

SERVICING The uler should not attempt to service
the appliance beyond that describ n the

oparating instructions. For all other sawining. corr-
ract the nearest Pioneer authorized service center.

ANrEmiA
- tum» win:

OUTDOOR ANTENNA GROUNDING - ll an

outside antenna is connected to the antenna
terminal, be sure the antenna system is
grounded on as to provide some protection
against voltage lurgeti and built up static
charges.
In the U.S.A. section BIO of the National Eleo-
trioal Coda, ANSI/NEFA No. 70-134. pro-
vides information with respect to proper
grounding of the mast and supporting struc.
ture, grounding ohha load-in wire to an Intan-
ne discharge unit, six. or grounding conduc-
tors. location of antenna-discharge unit, con-
nectlon to grounding electrodes, and re
quiramants lor the grounding electrode. Sea
Fig. A.

3) Use No, 10 AWG (5.3 mm)
copper, No. a AWG (3.4
mrrll llumlnum, N0. 17
AWG (1.0 mmi copper-
clad steel, bronze wire, or
larger as ground wire.

b) Secure antenna leetHrT and
ground wires to house with
stand-oft insulators spaced
from 4 (eat (1.22 motors) to
6 feet (133 meters) apart,

cl Mount antenna discharge
unit as closely as possible to
where load-in enters house.

man on
wsumens a

to murmur» d) Use jumper wire not smaller

-rsmrluu.s or rnonucr
than No.8 AWG (13.3 mm'I
copper or equivalent when
-;l§'§,§,{:fl Wig separate antennaqround-
cmrwrmunct irlp electrode la used.
murmur Gpounn
wrrrsra
Gloom)
rowsn ssnwcs Aw;
cwunoluc aircrrrops_svsrsu
r. c. miter nmu WV pool mm mm
count»: I In
true 'HE um tr
W" lr ascunan air
It weirdness sea
Flo ,A u use srmuu near ill,

IMPORTANT 1

The lightning flash with arrowhead, within an
oqullateral triangle, is intended to alert the uaar of the
preeenoe oi uninsulated "dangerous voltage" within the
products enclosure that may be of sufficient magnitude
to constitute a rink of electric Shook to persons.

CAUTION

Risk, OF ELECTRIC sHOCK
DO NOT OPEN

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK. DO
NOT REMOVE COVER IOR BACK), NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL,

The exclamation point within an equlleteral triangle is
intended to plan the user at the presence of important
operating and mlintenlnol (servicing) Instructlona in
the literature accompanying the appliance.

IMPORTANT 2

If the apparatus is fitted with Al: mains power outlettsl,
see REAR PANEL FACILITIES Ior convenient Cannes»
(ion of additional Hi-Fi componentls). Make all connec-
tions to the AC outletlsl and the signal terminals first.
Connect the plug to the wall socket last, make sure that
the power switch is cit. Disconnect the wall plug when
the equipment is not in (regular) use, 9.9, when on
vacation.

FOR USE IN THE UNITED
KINGDOM

WARNING: This plug must only be connected to
electronic apparatus seuippod with suitable
sockets.

Otherwise cut on and disposer at the plug. and rlt
an appropriate one In accordance with the instruc-
tion below,

The wires in this mains land are coloured in accordance
with the following code:

Blue: Neutral

Brown: Live
AS the colours of the wires in the mains lead of this ap-
paratus may not correspond with the coloured marking
identifying the terminals in your plug proceed as
follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or col-
oured black.
The wire which is coloured brown must be connected to
the terminal which is marked Mth the letter L or Dol-
nured red.