Pioneer a 207 owners manual

Page 1

GD pIONEEIT

The Art of Entertainment

A-ZO7
A-lO7

STEREO AMPLIFIER

Operating instructions

EngHsh

van...

.a. ......a.. A7207 Dired Energy MOS

fl-u n

Thank you for buying this PIONEER product.

Please read through these operating instructions so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in a safe place for future reference
In some countries or regions, the shape of the power plug and power
outlet may sometimes differ from that shown in the explanatory
drawings, However, the method of connecting and operating the unit
is the same.

The illustration shows the A-207.

WARNING: TO PREVENT FIRE on SHOCK HAZARD,
DO NOT expose THIS APPLIANCE TO RAIN on
MOISTURE.

HWPORTANT

The lightning flash with arrowhead symbol, wIIhIn an
equilateral triangle, :5 intended to alert the user to the
presence of uninsulated dangerous voltage' within the
product's enclosure that may be of sutlicient magnitude
to constitute a risk oi electric shock to persons.

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). N0 USERSERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

The exclamation point withm an equilateral triangle Is
Intended to alerl the user to the presence oi important
operating and maintenance (servicingl instructions in the
llterature accompanying the appliance.

Page 2

Information to User

Alteration or modifications carried out without appropri-
ate authorization may invalidate the users right to oper-
ate the equipment.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit or electric
shock. Do not place the unit, a piece of furniture, etc., on the
power cord, or pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords should be routed
such that they are not likely to be stepped on. A damaged
power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it
damaged, ask your nearest PIONEER authorized service
center or your dealer for a replacement.

MAINTENANCE OF EXTERNAL SURFACES

0 Use a polishing cloth or dry cloth to wipe off dust and
dirt.

0 When the surfaces are very dirty, wipe with a soft cloth
dipped in some neutral cleanserdiluted five or six times
with water, and wrung out well, and then wipe again
with a dry cloth. Do not use furniture wax or cleaners.

0 Never use thinners, benzine, insecticide sprays orother
chemicals on or near this unit, since these will corrode

the surfaces.

2

En

VOLTAGE SELECTOR SWITCH

Only multi-voltage model is provided with this switch.

Main voltages in Saudi Arabia are 127 V and 220 V only.

Never use this model with 110 V setting in Saudi Arabia.

The line voltage selector switch is on the rear panel. Check

that it is set properly before plugging the power cord into the

AC outlet. If the voltage is not properly set or if you move to

an area where the voltage requirements differ, adjust the

selector switch as follows.

1. Disconnect the power cord.

2. Use medium-size screwdriver.

3. Insert the screwdriver into the groove on the voltage
selector and adjust so that the tip of the arrow points to the
voltage value of your area.

new aqav
1 10v 1u-1e7v