Philips dcp 850 service manual
This is the 37 pages manual for philips dcp 850 service manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.
Extracted text from philips dcp 850 service manual (Ocr-read)
Page 1
DVD Portable Player
@Wflee
emcee
ervrce
DCP850
All version
TABLE OF CONTENTS
Safety Instructions ....................................
Instruction for Use ..........
Mechanical lnstructions.... ........
Troubleshooting .........................
Overall Block Diagram.... ..........
Technical Specification & Service Tips ..........
Electrical Diagram .......................................
Exploded View Diagram & Service Part List....
Revision List ............................................................. 9
Chapter
piano--
©Copyright 2005 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may by reproduced, stored in a
retrieval system or transmitted, in any form or by any means, electronics,
mechanical, photocopying, or othen/vise without the prior permission of Philips
Version 1.1
314178531651
PHILIPS
Page 2
1.0 TECHNICAL SPECIFICATION
General
Dimensions (W x H x D):
Weight:
Power supply:
Power consumption:
Operating temp. & FtH:
Video System
Audio System
Output voltage 1kHz:
THD 20-20kHz (%):
Dynamic range:
Signal/Noise ratio:
Frequency response (20-
20kHz):
Channel Separation 1kHz
Channel Balance 1kHz
Current consumption
210x 39 x 178mm
1.1 kg
DC 6.2-15.0V
9W
-10-50degC / 40-90%
NTSC/ PAL / AUTO
2+/-0.2V
=3%
>/=70dB
>/=70dB
+/-1 dB
>=60dB
<2dB
DVD, Picture-CD,
SVCD. Video CD, MP3-
CD, CD-FI/CD-RW,
WMA-CD, DVD-R, DVD-
FIW, DVD+R, DVD+RW,
SD/MMC Card
Playback disc type:
DVD / VCD lJPEG/
MPEG4 / DIVX3,4,5,6
Video Playback Format:
CD/MP3, MP3-DVD,
WMA
Audio Playback Format:
Disc Diameter 12cm
Pixel specification
Zero bright-dot & max. 3 dark-dots
DC-IN SUPPLY (9V)
Battery Charging Current
| 450 +/- 50mA
BATT. SUPPLY
Factory Service Mode (FSM)
Power Off
Playback with TFT on To check the software version and change
Playback Wlthoui TFT 0 region code of your DVD Portable
Playback time
Headphone out (headphone output load 2x16 ohm)
Maximum output power:
Frequency response:
SNFt (A-wght):
THD (0.2-20kHz):
Left-Right Channel
Separation:
Left-Right Channel
Balance:
Supported disc type
10mW
+/-1 dB
>70dB
1%
>/=50dB
=1dB
lmlLVIm VI DE 0'
....U.ao a
Video Playback
Formats:
Audio Playback
Formats:
diefiy .
1. Power ON the DVD player and open the DVD
door
2. Press the SETUP" button on remote control,
then select the Preference MENU
3. Press the remote button in the sequence as
9 -> 6 -> 5 -> 3
4. The LCD display showed the existing region
code. Press A (navigation up) or V
(navigation down) repeatedly to select the
number from O to 6.
5. Refer below table for your region code setting
Region Code Region
I USA
2 EUROPE
3 ASIA PACIFIC
4 AUSTRALiA. NEW ZEALAND LATAM
5 RUSSiA. iNDiA
6 CHiNA
Select 0 setting = Region Free (confidential)
Procedure on how to upqrade the software of
the DVD Portable
For the best performance of your DVD Portable.
Check www.philips.com/supporf for latest
software upgrades available.
A) By CD»HOM
1. Download the PHILIPSBIN file from the Philips
support site
2. Unzip the tile and then burn it into a CD-ROM to
make a disc for upgrade