Philips cd r 870 owners manual

Page 2

GENERAL INFORMAT

Important note for users in the UK

Mains plug
This apparatus is fitted with an approved 13 Amp plug.
To change a fuse in this type of plug, proceed as follows:

1. Remove fuse cover and fuse.

2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSl
approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place. If the mains plug
contains a fuse, this should have a value of 5A. If a plug without a
fuse is used, the fuse at the distribution board should not be greater
than 5A.

Note:
The severed plug must be destroyed to avoid a possible shock
hazard should it be inserted into a 13A socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured in accordance with the
following code:

Blue - 'Neutral' ('N); Brown - 'Live' ('L')

1. The Blue wire must be connected to the terminal which is
marked with the letter 'N' or coloured Black.

2. The Brown wire must be connected to the terminal which is
marked with the letter 'L' or coloured Red.

3. Do not connect either wires to the earth terminal in the plug
which is marked by the letter 'E or by the safety earth symbol or
coloured green or green-and-yellow.

Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.

Copyright:
Recording and playback of material may require consent. See
Copyright Act 1956 and The Performers Protection Acts 1958 to 1972.

For Customer Use:

Read carefully the information located at the rear plate of your
CD-Recorder and enter below the Serial N°.
Retain this information for future reference.

Model N°. .............. CDR870/880 ..........................

Serial N ......................................................................................

DK

Advarsel:
Usynlig laserudstraling ved abning nér sikkerhedsafbrydere er ude af
funktion. Undga udsaattelse for stréling.

S

Varning!

Om apparaten anvands pa annat satt an i denna bruksanvisning
specificerats, kann anvandaren utsattas for osynlig lasersfralning,
som overskrider gransen for laserklass 1.

SF

Varoifus!

Laifteen kéyttaminen muulla kuin tassa kayttfiohjeessa mainitulla
tavalla saat'taa attistaa kéyttajan turvallisuusluokan 1 ylittavalle
nakymattomalle lasersateilille.

LASER SAFETY

This unit employs a laser. Only a qualified service person should
remove the cover or attempt to sen/ice this device, due to possible
eye injury.

NEVER MAKE OR CHANGE CONNECTIONS WITH THE POWER
SWITCHED 0N.

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE OR OTHER
UNSAFE OPERATION.

The CDR870l880 is in conformity with the EMC
directive and tow-voltage directive.

77*, V7T¥ 777 \
1 i CLASSt LUOKANI
LASER PRODUCT LASERLAITE
. jLASEFtAPPAFtAT.
L,:::' ::;:,,f a