Philips az d 102 owners manual

Page 2

4EN 1 Important  Read these instructions.  Follow all instructions.  Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.  Do not install near any heat sources such as radiators, heat registers, stoves, or       produce heat.  Protect the power cord from being walked on or pinched, par ticularly at plugs, convenience receptacles, and the point where they exit from the unit.         by the manufacturer.  Unplug this unit during lightning storms or when unused for long periods of time.      !   personnel. Ser vicing is required when the unit has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the unit has been exposed to rain or moisture, does not operate normally, or has been dropped.  Batter y usage CAUTION – To prevent batter y leakage which may result in bodily injur y, proper ty damage, or damage to the unit:  Install all batteries correctly, + and - as marked on the unit.  Do not mix batteries (old and new or "   #$  %%  Remove batteries when the unit is not used for a long time.  The unit shall not be exposed to dripping or splashing.  Do not place any sources of danger on   %% !  "& $   %  Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning Never remove the casing of this apparatus. Never lubricate any par t of this apparatus. Never place this apparatus on other electrical equipment. Keep this apparatus away from direct sunlight, naked )   % Never look into the laser beam inside this apparatus. Ensure that you always have easy access to the power cord, plug or adaptor to disconnect this apparatus from the power. Mains fuse This information applies only to products with a UK mains plug. *      7       plug. If you replace the fuse, use one with:  the ratings shown on the plug,  a BS 1362 approval, and  the ASTA approval mark. Contact your dealer if you are not sure about what type of fuse to use. Caution: To conform with the EMC directive ;<<=<>?@$         the power cord.