Phase Linear 3300 Series Two Owners Manual

Page 1

3300 SERIES TWO
PREAMPLIFIER

OWNERS MANUAL

Aux

(é: fig; fig fig we g, g, Q

U IE POHLRI UK [)15 I {PREV}

Page 5

Please lollow these instructions when
installing the Model 3300 preamplifier:

PREAMPLIFIER CONNECTIONS
1. Initial Settings:

a.
b.
c.

d

e.

f.

AC Line Cord not plugged in,
Power switch in out position.
Volume control fully counter-
clockwise

All pushbuttons in out
positions.

Balance control in center
detent position,

Bass and Treble Tone Contour
controls centered,

2. External Equipment (See Illus-
stration 2):

3,

Plug the shielded phono leads
from turntable into the Phono
input, first removing the factory
installed shorting plugs. Plug
the AC line cord from the turn-
table into the unswitched AC
outlet on the rear of the Model
3300. Connect the ground wire
from the turntable to the Chassis
Ground lug.

. Plug the shielded leads from

the tuner Into the Tuner inputs
and connect all other equip-
ment such as tape decks into
the appropriate inputs

C.

INSTALLATION INSTRUCTIONS

For proper hook-up of auxiliary
equipment Into the tape monitor
loop. please refer to the manu-
facturers instruction manual.
Plug the AC line cords from the
outboard units into the switched
outlets on the rear of the 3300
Connect the Model 3300's main
outputs. either SW (switched) or
UNSW (unswitched) depending
on headphone listening pre-
ference, to the power ampli-
fier's inputs using shielded
leads. The power amplifier
should be plugged into a swit<
ched outlet on the 3300, pro-
vided it does not exceed a max-
imum of 600 watts.

3. Turn-on:

a. Plug in the AC line cords Leave

the preamplifier turned off.
Make sure the input level con-
trols (if present) on the power
amplilrer are turned down and
the unit is off (if controllable).
Re-check all connections and
turn on the Model 3300 Pre-
amplifier. Wait approximately
10 seconds tor the solid state
output muting circuit to release
before continuing.

. Turn on the program source

(turntable. tuner. tape, etc.)
Select the desired source by
rotating the Selector switch to
the appropriate position,

. Turn on the power amplifier

and. it applicable. advance the
level controls about 3/4 clock-
wise. When using a power am-
plifier without level controls,
the 3300 Volume knob will pro
vide sole control of the output
level.

. Advance the Model 3300 vol-

ume control until the desired
level is obtained. If no sound is
heard through the system turn
everything off and re-check all
connections and setting.

. Refer to the Operating Instruc-

tions portion of this manual for
correct operation of the Model
3300

lluslralionf?