Panasonic rf u300eg user manual

Page 1

,
1 Turn on the units
power.

(b/I

Press O .

To turn the power off, press
the button again.

When the power is turned on
again, the broadcast station that
was last tuned in when the power
was turned off, will be tuned in.

,
2 Select the broadcast station.

to select the desired station.

FM 87. 60
TU ED

TUNED appears for
about 1 second when a
station is tuned in.

I Automatic tuning
AUTO

When -MWBX Is pressed, automatictuning starts, and It
stops at the station which is tuned in first. Repeat this
until the station you want to listen to is tuned in.

Depending on the quality of the reception, automatic tuning may not be

ossible.
p AUTO

. . C]
- During tuning press «am to stop.

Standby/on switch (4)] I)

Press to switch the unit from on to

standby mode or vice versa.

In standby mode, the unit is still

consuming a small amount of power.

to adjust the
volume. (0 to 50)

VOLUME 28

To improve reception

Adjust the length and angle of the rod
antenna to obtain the best reception.

If you take hold of the units rod antenna
and move it from one place to another,
you may damage the unit.

To move the unit, make sure you pick it
up by the handle on the rear panel, and _
then move it. '

RDS broadcasting

This unit can display the text data transmitted by the radio
data system (RDS) available in some areas.

The panel display is automatically switched when a
Program Service name (PS) or Radio Text message
(RT) is received.

When a Program Service name
(PS) is received

I
xxxxxxxx
############-When a Radio Text message
(RT) is received

- RDS displays may not be available if reception is
poor
~ During timer operations the unit will not automatically
switch over to tflifiDS displays. To indicate the RDS
displays, press D"
L

4