Panasonic rf 3700

Page 2

IMeasurements and Adjustments
I Alignment Instructions

READ CAREFULLY BEFORE ATTEMPTlNG ALIGNME T

t . Set volume control to maximum.
2. Set band switch to AM or FM,

3. Set power source voltage to 6 V.

4. Output oiSlgnal generator should be no higher
than necessary to obtain an output reading.

I MW,LW,SW Alignment

(3)

(4)

(7)

(8)

SIGNAL GENERATOR or W lNDlCATOR
BAND SWEEP GENERATOR RADIO DIAL (ELECTRONIC ADJUSTMENT REMARKS
*A SETTING VOLTMETERor (Shown in Fig.1)
CONNECTIONS FREQUENCY OSCILLOSCOPE) l
AM-IFALlGNMENT
:jvsgrglr'tjrfsgf0 459 kHz (2,28) Point of non. Headphm Jam" (3211'
. 450 kHz (EG) mlerlerence.(on/ Fahncalo the plug as shown T2 (AM IFT) Adlusl lot maleum
MW wue and tadlate 30% Mod about SOOKHZ) in Fig.2 and then connect output.
signal into loop of ' the lead wires 0! the pug to
men/EL at 400Hz the measuring instrument
LW-FiF ALIGNMENTiFOR E,EB AREA)
LW ,, 144 kHz Tuningcapacflor N L3 (LW OSC ..
fully closed. Cell)
LW .l 162 kHz t Tune to slgnal n ['1] L64 (LW £31133: 'grdmgfiigflp
ANT cm by movmgcollalong
the territe core.
Adjust {at maximum
T2 LW
LW .l 270 kHz ll " iNTEIrimmer) output.
W l Repeatsteps(2l~l4),
['1] Fix antenna coil with wax alter completlng alignment.
l
MWVRFALIGNMENT (FOR E.EBAREA}
MW u 522 kHz Tuningcapacitor ,, L2 (MW 050 Adlust tor maximum
fully closed. Coil) OUIDUt-
MW .. 603 kHz Tune to signal -l [-2] L672 (MW 33:33: 3:37.333?
ANT CO") by movingcoil along
the ierrlte core.
Adjust for maximum
MW .. 1404 kHz H l- 2:17g-hfiywvmer) output.
Repeat steps (5H7).
MWrRFALlGNMENUFOR EGAREA) 5
MW ,, 522 kHz Tuningcapacltor .. L3 (MW 050 Adlust lormaximum
fullyclosed. Cell) output.
W l. 603 kHz Tune to slgnal u ['2] Ls (MW 23:23: fgdmggum
ANTCO by moving callalong
l the territe core.
7 Adlustiorrnaxlmum
T2
MW .. 1404 kHz .. ll iNTwIVerer) output.
1 Repeatsteps/8)~(10).
[2] Fix antenna coil with wax alter completing alignment