Onkyo HR 10 Owners Manual

Page 1

g

HR-10/HE-1o
°NkY° HE-50/HE-50AC

MULTIPLE ROOM REMOTE SYSTEM
FERNBEDIENUNGSSYSTEM FUR MEHRERE RAUME
SYSTEME DE TELECOMMANDE MULTISALE
SISTEMA REMOTO MULTISALA
MEERKAMER-AFSTANDSBEDIENINGSSYSTEEM
FJARRSTYRNINGSSYSTEM FOR ELERA RUM
SISTEMA DI COMANDO A DISTANZA PER AMBIENTI
MULTIPLI

"1mm" Mun!
Murine-lbw
Manuel d'lm
Manual de mm
Gehrulksaanwlwm
Bruksammng
Won! W "m

.
0.

38:33

Page 11

Operation
_

0 Remote control operation wrthtn the math room Is the
some as that tor conventional operatton ll component:
are connected as shown In Frg 3 they can be controlled
only no the mam room
I To control components tn the main room from another
room, connect them as shown m ths t and 2. then
operate the system accordmg to the procedure below
(1) Turn on the power of the components tn the them
room. keep the volume control at low level, then
set the B lSUB ROOM] swrtch lot speakers to the
ON position When you are not ltstentng In the
mam room. turn the AlMAIN) switch lot speakers
In the mom room to the OFF poeltton

(2) Operate the remote control by dtrectmg It towards
the HRJO In another room

NOIES:

l. thh certam remote controllers. sort-no the SENS
Swvtch to the LOW pas-hon makes ooeranon more
eflectwe

2 The HRJO In another room does not display the
status at components bearmg the fin mark m the
math room

3 II components are Installed where they cannot be
observed lrom the crowds. pay attentton to heat
radtataont and locate them tn such a way that power
to the components can be turned on when they are
not In use

Troubleshooting guide.

O The system does not operate.
Frrst check the connection, then check whether Htho
POWER mdlcetor t: II!

II-

(l)

(2

.4")

The tndtcetor II not I" even though the connectton
IS correct mean: that power 1: not supphed to the
tuner smut-her. or the cable rs unconectly connected
0' out

It the mdtoetor Is In. check whether the RECEIVED
Indlcator I: lit when the remote controller ts not
operated

II II ts Int. the HRJO ts recetvtng Interference Irorn
fluorescent light: In lhls case. nlt the HRJIO
backwards. lorwards or :tdeweys to «trust the angle
at the unit so that strong llght does not radtate
dtrectly at the tront panel of the amt

It the Indicator I: not In. operate the remote con~
uoller by dlrecttng It towards the HRJO

It the RECEIVED mdlcnor does not "ash. thu re
mote transmitter or HR") is detectlve It the
ptoblem cannot be solved, contact an ONKYO
servtce centerv

It the RECEIVED lndlcltor (lashes. It means that
the connection cable is cut.

I'IR components can be operated by a remote con
troller manufactured by ONKYO but not by another
maker.

FIISI check that the components at other makes can
be controlled by a remote controller 0' the same make