Nad 7240 PE Service Manual

This is the 20 pages manual for Nad 7240 PE Service Manual.
Read or download the pdf for free. If you want to contribute, please upload pdfs to audioservicemanuals.wetransfer.com.

Page: 1 / 20
Nad 7240 PE Service Manual

Extracted text from Nad 7240 PE Service Manual (Ocr-read)


Page 1

NAD SERVICE
MANUAL

7240PE

STEREO RECEIVER

Page 2

ALIGNMENT METHOD

AUDIO SECTION 7240PE
. IMPORTANT

Sneaker Impedance switch should be in 8 ohm position while adjusting center voletge and idling current.

INITIAL ADJUSTMENT (No load connected)
A. CENTER VOLTAGE
l. Connect DC millivoltmeter to L channel output terminals.
2. Turn on and adjust too v +- 3an with View (10KB). Connect DC millivoltmeter to R channel output terminals and
adjust VNOZ to 0 V +- 30.
9. IDLING CURRENT
1. Remove solder short across R471 and R472.
2. Connect DC millvoltmeter across nm (1 ohm) (outnut transistors collector resistor) and adjust vnroa (Hill)
for BMW reading on meter.
Repeat adjust with W04 (1K8), connecting meter across Rdlzli onml
3. leave power on for rinimum 5 minutes.

. FINAL ADJUSTMENT
C. CENTER VOLTAGE
l. Repeat Step A above,
D. IDLING CURRENT
1. Repeat step 8 and must with W403, VRAN for 30mV reading on meter.
2. After the alignment is finished, l ohm resistor RULRUZ is shorted by solder short.


wen: :smen muect A01 >¥

rap /
\..:1

633:} vmm :9;ch gmw w.-

vmr


VRAOZ

liEAKEi-Z

Q
Q 9
©

vanes

@ vaflr «pimp. ~Ew§~v AD

Hum
\ VPI) -: n w Lune! Am

e AMPLIFIER ADJUSTMENT POINTS

_...5....