Luxman f 114 service manual

Page 2

Disassembly Instructions

Volume Control
For Board Display PAC. Board

1. Caution on Removing the Front Base

Hooks (A) /

You cannot remove the Front Base unless you I I

remove the Front Panel first when you remove the

Front Panel, follow the procedure given below

(1) Remove the four screws that (ix the lower Part
of the Front Panel. To remove the Front Panel,
push the panel In the direction of arrow C as
you press down Hooks (A) (located in three
plares) in the direction 01 arrow B using a
minus (,) screwdriver (see Figures I and 2).

Front Panel

Figuer 1

2. Caution on Removing the Display P_C.Board \
Driver
Remove the [our screws fixing the Board. Remove the
Display Ptctaoard as you press Hooks (D) (located in
six places) in the direction of arrow E using your fingers
(see Figures 3 and 4).
Note : Be careful when you handle Hooks (A) and (D)
They may break easily

a /

Front Panel

Front Base /
Figuer 2

Power Switci

Volume Control PC. Board
RC. Board Hooks (D) ( F
Rear Volume 1 Display 8"
; Switch PC. Board, , ' RC, Board 1

l , /~ g i

3. Caution on Removing the Volume Control
P.C.Board

To prevent (utting off the (onnertor (F) whkh

comes out from the Volume Indicator PVCVBoard

at the rear of the Volume Control Knob, disconnect
the connector betore removing the knob (see Figure 5)

Input Volume Speaker Swrtch
Conlrol P.Cs Board RC. Board

Figuer 3
Volume Control Knob
/
Volume Ingicator /
\ _,
P.Ct Boar \ _ Hock (D)
r
E . c _
Display 7 .-
P 0 Board FtUnt Edge
Volume Control N/
P C, Board _
Figuer 4
Connector (H
Figuer 5