Kenwood XDDV 80 Owners Manual

Page 2

Introduc tion

Before applying power

Units are dsigned for operation as follows.
U.5A. and Canada
Europe and U.K.

For the United Kingdom

. AC 120 Vonly
.AC 230 Vonly

XDVDV Series (EN/K, M IX,

& Caution : Read this section carefully to ensure safe operation.

Australia .................................................... A C 240 V only
*Other countries .. A C 110-120 / 220-240 V switchable
*For other countries

Factory fitted moulded mains plug

1. The mains plug contains a fuse. For replacement, use only
a 3-Amp ASTA»approved (BS l362)fuse.

2. The fuse cover must be refitted when replacing the fuse in

AC voltage selection

The AC voltage selector switch on the rear panel is set to the
voltage that prevails in the area to which the unit is shipped.
Before connecting the power cord to your AC outlet, make
sure that the setting position of these switches matches your

the moulded plug. line voltage. If not, it must be set to your voltage in accordance

3. Do not cut off the mains plug from this equipment. If the With the following direction.
plug fitted is not suitable forthe power points in your home

or the cable is too short to reach. AC voltage selector switcha

A power point, then obtain an appropriate safety approved

extension lead or adapter, or consult your dealer. If none- Ac 1m. Ac zzur
theless the mains plug is cut off, remove the fuse and HOW-I EMT
dispose of the plug immediately, to avoid a possible shock m
hazard by inadvertent.
Connection to the mains supply.

IM PORTANT :
The wires in the mains lead are coloured in accordance
with the following code:

Move switch lever to match your line voltage with a small
screwdriver or other pointed tool.

Note:
Blue : Neutral
Brown : Live Ourwanantydoes notcoverdamage caused byexcessive line
Do not connect those leads to the earth terminal of athree- voltage due to improper setting 0f the AC voltage SGIECtOI'
pin plug. switch.
safety preca uuons & Caution : Read this section carefully to ensure safe operation.

WARNING :TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.

CAUTION: TO REDUCE THE RISKOF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER-
VICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION

alsv. or stzcmc 91ch
do nor am.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRI-
ANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DAN-
GEROUS VOLTAGE" WTTHIN THE PRODUCTS ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNTTUDE TO CONSTITUTE A RISKOF ELECTRIC SHOCKTO PERSONS.

A

THE EXCLAMATION POINT WITHIN AN EOUILATERAL TRIANGLE IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SER-
VICING) INSTRUCTIONS IN THE LTTERATURE ACCOMPANYING THE APPLIANCE.

A

The marking of products using lasers
(Except for some areas)

CLASS 1
LASER PRODUCT
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser

beams that are of a weaker class. There is no danger of
hazardous radiation outside the unit.

Page 21

Let's put out some sound

In regard to input switching be-

tween VlDEO and AUX
When theVlDEO/AUX key is prased, the input
is switched to the AUX terminal at the rear of
the unit. Each time the VIDEO/AUX key is
pressed for morethan 2 seconds, the display is
switched between VIDEO and AUX.

VlDEO/AUX

(a

Basic use method

.Selec ting the desired input

W @
(ii/y TUNER
Q

TAPE A

@

TAPES

rm

:53

m

B Volume adjustment
YONLUEE To decrease To increase

Q3

To decrease, Ta incm

Muting the sound temporarily

MUTE

Listening through headphone
Insert the headphone plug into the PHONES jack.

PHONES

o The sounds from all speakers are cut off.

21

XDVDV Series (EN/K, M IX,

0 When one of the keys on the left is pressed while the power is
off, the powerw ill be switched on automatically and the inputw ill
be selected.

a Whenadisc is set inthe disc trayand the DVD/ CD keyis pressed,
disc playback will start automatically.

Trays without a disc will be skipped.

c When a cassette is set in the holderand the TAPE key is pressed,

tape playback will start.

The mark of the disk being
played flashes.

eel?

V :ELEL'TDR p m mm
35:45/(3 . > g

SD

An example of DVD

0 Press MUTE key.

a Press again to resume the original volume.
0 The sound muting is also cancelled when the volume is con-
trolled.

This unit offers various surround modes, but it switches
automatically to stereo mode when headphones are
connected.

For listening via the speakers, disconnect the headphones
plug and set the listening mode again. (See page 53.)