Kenwood X 92 4450 00 Service Manual

Page 2

X92-4430-0x
X92-4450'0X NOTE FOR HANDLING MECHANISM ASSY

N Pick is under the finger, it N Dont touch the lever be- N Don't have the center of
may touch. cause the trigger lever entrance because the disc
comes off. insertion mouth is trans-

formed.

P|CK Up - Don't touch in the frame, since grease is
applied to the parts.

SPINDLE MOTOR - Don't applied grease to the roller.
' Don't touched PICK and SPINDLE MOTOR.

ROLLER

OK OK NG

Page 10

X92-4430-0X
X92-4450-0X

2) Lowering the clamper (for disc chucking) lni ial position

As slider (Fl) moves, the plate spring

section engaged with it moves along its C'ampe' \ P'ae Spring crampe, Engaged condition
groove and lowers the clamper chassis swarm) Chases assy
L,:D
assembIY- <2 r: KG
m...
The following figure shows the flow of @
operation. a

3%
3%
k
%

(4) How to lower the rollers

1) Disc chucking completion position
When the disc in this position, the rollers are located below
the disc and in contact with it.
To rotate the disc for playback, it is required to separate
the rollers from the disc.

2) Lowering the rollers (Disc playback

C:
position) C
As slider (Ft) moves, the roller lever shaft
engaged with a groove on slider (R)
moves along the groove and lowers the C:
rollers. C
The following figure shows the flow of
operation.

In contrast to the downward movement of the rollers, the extremity of the roller lever starts to
be raised.

rll

At the lowest position of the rollers

The roller lever extremity comes in the position shown in the figure. Here, it plays a role of
stopper for preventing insertion of more than one dlSC.

27disc insertion A
prevention

Final Dasilm

10 <2 Rollers are separated from the disc.