Kenwood KRV 7070 Owners Manual

Page 1

ICC/WNEDI

Don nlmiilcd l'mm www Munualslib com in ll]lill\ w liLh (Bibi

AUDIONIDEO RECEIVER

KR-V707O
INSTRUCTION MANUAL

KENWOOD CORPORA'HON

For your recnrds

Record the serial number, found on the back of the unit. in the spaces designated on the warranty
card, and in the space provided below. Refer to the model and serial numbers whenever you call
upon your dealer for information or service on this product.
Model____.-__._. Serial Number

Unpacking

Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. if your unit is damaged or fails to operate,
notify your dealer immediately. if your unit was shipped to you directly. notify the shipping com-
pany without delay. Only the consignee (the person or company receiving the unit) can file a claim
against the carrier for shipping damage.

We recommend that you retain the original carton and packing materials for use should you trans-
port or ship the unit in the future. .

Accessories

FM indoor antenna (1) AM loop antenna in Loop antenna stand [1}

grey.®

Antenna adapter (1) Remote control unit (1) Batteries (Fifi/AA) (2) AC plug adaptor (il

i )7 e6

" Use to adapt the plug on the power cord to the shape of the wall
outlet. (Accessory only for regions where use is necessary.)

Boo-137040 @(K, P, M. x. Y)

Page 2

2 11m.

ta BHSUG 5a 2 GI '

Knv7u7o [En
Units are designed for operation as follows.

U.S.A. and Bennie .. ..... ...........................Ac 1Z0 Vauly
Australia ............... A6240 V only

Other countries... ......AE "(MM/220440 szitchaltle

A6 who a selection .
This unit caperates on 110 - 120 volts or 220 - Ac "ms'hmmfmh
240 volts AC. The AC voltage selector switch "
on the rear panel is set to the voltage that pre-
vails in the area to which the unit is shipped. . _ _ .
Before connecting the power cord to your AC m11o_12m1. . p mega _ 240v. ' . - ~ .
outlet make sure that the setting position of ' ' ,
this switch matches your line voltage. If not. it a
must be set to your voltage in accordance with
the following direction.

Move switch lever to match your line voltage with
a small screwdriver or other pointed tool.

Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC Voltage selector switch.

ZMJIMMHMSWW WW WWWW

WARNING. TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
on MOISTURE

:cmic snocx (OR BACK). NO USER- SERVICEABLE PARTS INSIDE REFER SERVICINGTO QUALIFIED
0 0 SERVICE PERSONNEL __ _ .

Ea _HAUTION fl CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER

THE LIGHTNING FLASH,W|TH ARROWHEAD SYMBOL WITHIN AN EOUILATERAL TRIANGLE. IS
INTENDED TO ALERT THE USERTO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE
WITHIN THE PRODUCTS ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TD CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINTWITHINAN EOUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO"
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE _

For the U.$.A.
F06 WARNING

This equipment may generate or use radio frequency energy Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an

unauthorized change or modification is made.

MUTE: .
This equipment has been tested and found to comply with the limits for a Class 3digital device, pursuant to Farm 5 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmfuL
interterence to radio communications. if it is not installed and used in accordance with the instructions. However, there is no guarantee that ,
intarierence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which
can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following
measures: W

- Reorient or relocate the reCeiving antenna.

- Increase the separation between the equipment and receiver. ,

- - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. .

- Consult the dealer or an experienced radio/TV technician for help.

For the 0.5.4.

Nate ta CATVsystem installer:
This reminder is provided to call the CATV system installars attention to Article 820-40 of the NEC that provides guidelines for proper
grounding and in particular. specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of

cable entry as practical.

DI)\\IIIOLILILLI l'mm www.Manualslib.Com manuals Search engine " '7
,1;